23 February 2026 in Measurement
3 June 2025 in IEEE Transactions on Instrumentation and Measurement
Precise jitter identification and extraction are critical for jitter decomposition, fault diagnosis, and bit error rate estimation in high-speed serial communications. Conventional methods depend on decision threshold and clock recovery, which discard significant signal information, as only threshold crossing points are considered. Additionally, the accuracy of jitter extraction is sensitive to errors introduced by histogram-based statistical computations and interpolation processes. This paper presents a novel jitter extraction method based on a signal transmission model that fully exploits the cyclostationary characteristics of the signal. By utilizing all signal points rather than just threshold crossings, this method eliminates the presetting modules and avoids statistical computations or interpolations, resulting in a simpler implementation and lower complexity. A theoretical model is developed to demonstrate that the phase of the cyclic autocorrelation function at the symbol rate frequency intrinsically encodes the jitter information for each symbol. The time interval error jitter can be extracted by computing the phase via the fast Fourier transform, followed by least squares correction to eliminate cumulative errors. Simulations under various jitter conditions validate the accuracy and robustness of the proposed method, showing comparable performance to conventional approaches while achieving superior accuracy in sinusoidal jitter scenarios. The effectiveness is further demonstrated through oscilloscope experiments, with relative errors below 1%, confirming its accuracy and practical applicability.
4 September 2026 in Measurement
1 October 2026 in Measurement
8 June 2026 in IEEE Transactions on Instrumentation and Measurement
Sampling clock jitter is a dominant factor limiting the dynamic performance of high-speed analog-to-digital converters (ADCs). Its impact on the signal-to-noise ratio (SNR) increases with input frequency. Existing jitter characterization methods face a dual challenge when applied to ADC sampling: (i) the sampling jitter manifests as a discrete-time sequence, and (ii) its power spectral density (PSD) distribution over the entire observation frequency range is not mathematically clear. In this paper, sampling jitter is modeled as the periodic sampling of continuous-time jitter from a physical perspective. Considering phase-locked loop (PLL)-based clock generation chains, the theoretical relationship among phase noise, time jitter, and sampling jitter is established to derive the sampling jitter PSD. The proposed theoretical model is tested on a practical clocking chain. For clock frequencies ranging from 200 MHz to 600 MHz, the root mean square (RMS) and maximum error bar of the mean squared errors (MSEs) between the measured results and the theoretical prediction are 0.23 dB and 0.63 dB, respectively.