Max Döbeli

Max Döbeli

Auto-generated profile, based on publicly available information

Max Döbeli

Laboratory of Ion Beam Physics, ETH Zurich, Otto-Stern-Weg 5, CH-8093 Zurich, Switzerland

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 July 2018 in Advanced Materials Interfaces
Verified
Journal Article
Closed access
PDF file
AOAlejandro Ojeda‐G‐P
Alejandro Ojeda‐G‐P
MDMax Döbeli
Max Döbeli
TLThomas Lippert
Thomas Lippert

8 July 2020 in Advanced Materials Interfaces
Verified
Journal Article
Open access
PDF file
JSJordi Sastre
Jordi Sastre
Agnieszka PriebeAgnieszka Priebe
Agnieszka Priebe
MDMax Döbeli
Max Döbeli
JMJohann Michler
Johann Michler
ATAyodhya N. Tiwari
Ayodhya N. Tiwari
YRYaroslav E. Romanyuk
Yaroslav E. Romanyuk
The high ionic conductivity and wide electrochemical stability of the lithium garnet Li7La3Zr2O12 (LLZO) make it a viable solid electrolyte for all‐solid‐state lithium batteries with superior capacity and power densities. Contrary to common ceramic processing routes of bulk pellets, thin film solid electrolytes could enable large‐area fabrication, and increase energy and power densities by reducing the bulkiness, weight and critically, the area‐specific resistance of the electrolyte. Fabrication of LLZO films has nonetheless been challenging because of lithium losses and formation of impurity phases that result in low densities and poor ionic conductivities as compared to bulk pellets. Here, a scalable method for fabricating submicron films of LLZO employing co‐sputtering from doped LLZO and Li2O targets is presented. A record ionic conductivity of 1.9 × 10−4 S cm–1 is measured for dense and uniform cubic‐phase Ga‐substituted LLZO films annealed at 700 °C in oxygen, which is comparable to the values in high‐temperature sintered pellets and outperforms by one order of magnitude the latest record for LLZO thin films as well as the typical conductivities in the well‐established LiPON electrolyte. This result is an important milestone to realize all‐vacuum deposited solid‐state batteries with higher power density.

1 March 2004 in Thin Solid Films
Verified
Journal Article
Closed access
DBD.L. Bätzner
D.L. Bätzner
ARAlessandro Romeo
Alessandro Romeo
MTM. Terheggen
M. Terheggen
MDM. Döbeli
M. Döbeli
HZH. Zogg
H. Zogg
ATA.N. Tiwari
A.N. Tiwari

1 September 2017 in Science Advances
Verified
Journal Article
Open access
PDF file
DBDaniel M. Balazs
Daniel M. Balazs
KBKlaas I. Bijlsma
Klaas I. Bijlsma
HFHong-Hua Fang
Hong-Hua Fang
DDDmitry N. Dirin
Dmitry N. Dirin
MDMax Döbeli
Max Döbeli
MLMaria Antonietta Loi
Maria Antonietta Loi
Colloidal quantum dots, and nanostructured semiconductors in general, carry the promise of overcoming the limitations of classical materials in chemical and physical properties and in processability. However, sufficient control of electronic properties, such as carrier concentration and carrier mobility, has not been achieved until now, limiting their application. In bulk semiconductors, modifications of electronic properties are obtained by alloying or doping, an approach that is not viable for structures in which the surface is dominant. The electronic properties of PbS colloidal quantum dot films are fine-tuned by adjusting their stoichiometry, using the large surface area of the nanoscale building blocks. We achieve an improvement of more than two orders of magnitude in the hole mobility, from below 10−3 to above 0.1 cm2/V⋅s, by substituting the iodide ligands with sulfide while keeping the electron mobility stable (~1 cm2/V⋅s). This approach is not possible in bulk semiconductors, and the developed method will likely contribute to the improvement of solar cell efficiencies through better carrier extraction and to the realization of complex (opto)electronic devices.

17 July 2013 in Physical Review Letters
Verified
Journal Article
Open access
PDF file
JWJ. S. White
J. S. White
MBM. Bator
M. Bator
YHY. Hu
Y. Hu
HLHubertus Luetkens
Hubertus Luetkens
JSJ. Stahn
J. Stahn
CSChristof Schneider
Christof Schneider
Single phase and strained LuMnO3 thin films are discovered to display coexisting ferromagnetic and antiferromagnetic orders. A large moment ferromagnetism (≈1μB), which is absent in bulk samples, is shown to display a magnetic moment distribution that is peaked at the highly strained substrate-film interface. We further show that the strain-induced ferromagnetism and the antiferromagnetic order are coupled via an exchange field, therefore demonstrating strained rare-earth manganite thin films as promising candidate systems for new multifunctional devices.

1 March 2009 in Applied Surface Science
Verified
Journal Article
Closed access
IMI. Marozau
I. Marozau
ASA. Shkabko
A. Shkabko
GDGheorghe Dinescu
Gheorghe Dinescu
MDM. Döbeli
M. Döbeli
TLThomas Lippert
Thomas Lippert
AWA. Wokaun
A. Wokaun