While liquid exfoliation is a powerful technique to produce defect-free nanosheets in large quantities, its usefulness is limited by broad nanosheet thickness distributions and low monolayer contents. Here we demonstrate liquid processing techniques, based on iterative centrifugation cascades, which can be designed to achieve either highly efficient nanosheet size-selection and/or monolayer enrichment. The resultant size-selected dispersions were used to establish quantitative metrics to determine monolayer volume fraction, as well as mean nanosheet size and thickness, from standard spectroscopic measurements. Such metrics allowed us to design and optimize centrifugation cascades to enrich liquid exfoliated WS2 dispersions up to monolayer contents of 75%. Monolayer-rich dispersions show relatively bright photoluminescence with narrow line widths (<35 meV) indicating the high quality of the nanosheets. The enriched dispersions display extinction spectra with distinct features, which also allow the direct estimation of monolayer contents.
Liquid phase exfoliation (LPE) is a commonly-used method to produce 2D nanosheets from a range of layered crystals. However, nanosheets produced by LPE display broad lateral size and thickness distributions and clear correlations between size and thickness, issues which limit nanosheet application-potential. To understand the factors controlling the exfoliation process, we have liquid-exfoliated 12 different layered materials, size-selecting each into fractions before using AFM to measure the nanosheet length, width and thickness distributions for each fraction. The resultant data shows a clear power-law scaling of nanosheet area with thickness for each material. We have developed a simple non-equilibrium thermodynamics-based model predicting that the power-law pre-factor is proportional to the ratio of in-plane-tearing/out-of-plane-peeling energies. By comparing the experimental data with the tearing/peeling ratio calculated from first principles, we find close agreement between experiment and theory. This supports our hypothesis that energy equipartition holds between nanosheet tearing and peeling during sonication-assisted exfoliation.
Identifying cheap, yet effective, oxygen evolution catalysts is critical to the advancement of water splitting. Using liquid exfoliated Co(OH)2 nanosheets as a model system, a simple procedure is developed to maximize the activity of any oxygen evolution reaction nanocatalyst. First the nanosheet edges are confirmed as the active areas by analyzing the catalytic activity as a function of nanosheet size. This allows the authors to select the smallest nanosheets (length ≈50 nm) as the best performing catalysts. While the number of active sites per unit electrode area can be increased via the electrode thickness, this is found to be impossible beyond ≈10 µm due to mechanical instabilities. However, adding carbon nanotubes increases both toughness and conductivity significantly. These enhancements mean that composite electrodes consisting of small Co(OH)2 nanosheets and 10 wt% nanotubes can be made into freestanding films with thickness of up to 120 µm with no apparent electrical limitations. The presence of diffusion limitations results in an optimum electrode thickness of 70 µm, yielding a current density of 50 mA cm−2 at an overpotential of 235 mV, close to the state of the art in the field. Applying this procedure to a high‐performance catalyst such as NiFeOx should significantly surpass the state of the art.