This paper describes a short-range transceiver architecture using frequency-hopped sinusoidal OOK pulses. Since signal bandwidth does not necessarily have to satisfy >500 MHz requirement like conventional ultra-wideband (UWB) pulses, the proposed transceiver named as a very-wide band (VWB) transceiver offers degrees of freedom to choose an optimum operation duty cycle in terms of energy efficiency, bandwidth efficiency, and communication range, while providing much lower operation duty cycle than that of narrow band OOK transceiver. The VWB transmission significantly relaxes the complexity of transceiver design without requiring advanced CMOS technology. In the transmitter, pulse generation circuit design is simplified with the duty-cycled sinusoidal signal compared to that in the impulse-radio UWB (IR-UWB) transmitter. In the receiver, an asynchronous energy detection topology is proposed to achieve robust energy detection by overcoming the synchronization issue as well as the saturation problem of the integrator circuit. A prototype 3-to-4 GHz VWB transceiver is implemented in 0.18 μm CMOS. The transceiver achieves the communication distance of >2 m at 1 Mb/s data rate with the peak-to-peak pulse amplitude of only 300 mV and the duty cycle of 0.6%, consuming 0.42 mW from a 1.8 V supply.
9 April 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief describes a high-speed auto-calibrated bit slicer for energy and envelope detection receivers. For robust bit decision, a digital-assisted calibration method with auto threshold estimation and auto phase acquisition is employed. The bit slicer consists of a phase-locked loop for multi-phase clock generation and a dynamic comparator in which the bulk voltage of the input transistor is trimmed for threshold voltage control. The proposed bit slicer is implemented in 65-nm 1P9M CMOS, occupying a total area of 0.07 mm2. Experimental results show that the bit slicer achieves a sensitivity of 6.1 mV at 1 GHz and consumes 1.6 mW from a 1-V supply.