Woogeun Rhee

Woogeun Rhee

Auto-generated profile, based on publicly available information

Woogeun Rhee

Tsinghua University

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 November 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MNMeng Ni
Meng Ni
XWXiao Wang
Xiao Wang
FLFule Li
Fule Li
WRWoogeun Rhee
Woogeun Rhee
ZWZhihua Wang
Zhihua Wang
This paper presents an improved correlation-based timing-skew calibration strategy with constant input impedance characteristics. A full sampling rate operating time-interleaved reference ADC (TI-RADC) whose interleaving factor is coprime with TI-ADC is introduced to replace the conventional single-channel reference ADC. This paper theoretically demonstrates that by setting an appropriate time interval between the sampling edge of TI-ADC and TI-RADC and aligning the sampling edge of each channel in TI-ADC with each other but not with the reference ADC, the skew of the TI-RADC would not affect the timing skew calibration of the TI-ADC. A prototype 13-bit 2-GS/s 8-way TI pipelined SAR ADC employing a 1-bit 3-way TI-RADC is fabricated in 28-nm process to verify the presented calibration strategy. Measurement results demonstrate the correctness of the calibration strategy and reveal that compared with using single-channel reference ADC operating at a decimated sampling rate, the spurs resulting from the time-variant input impedance are suppressed more than 20 dB. The prototype ADC achieves an SNDR of 60.36 dB with a near Nyquist rate input when operating at 2-GS/s. The power consumption of the prototype ADCis 252.6 mW (Including the 4.1 mW estimated digital calibration), which translates into a Walden FoM of 148.3-fJ/conversion-step.

10 May 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
YZYining Zhang
Yining Zhang
HSHaixin Song
Haixin Song
RZRanran Zhou
Ranran Zhou
WRWoogeun Rhee
Woogeun Rhee
ISInbo Shim
Inbo Shim
ZWZhihua Wang
Zhihua Wang
A hybrid low-dropout regulator (LDO) with exponential-ratio array (ERA) and analog based transient voltage compensation is implemented in 65-nm CMOS. The hybrid LDO (HLDO) is capable of reducing a voltage drop upon load change by more than 70%, and the ERA enables fast tracking time, enlarging dynamic range of the digital loop. The HLDO achieves 99.7% current efficiency with the output dynamic range of 0.01-to-40 mA (4000x) and obtains the transient output voltage drop of 55 mV for a load current jump of 0.55 mA from 20 μA. When both the dynamic and the static performances are considered, the proposed HLDO shows the state-of-the-art performance among other recent DLDOs and HLDOs.

7 March 2017 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
DLDang Liu
Dang Liu
XNXuwen Ni
Xuwen Ni
RZRanran Zhou
Ranran Zhou
WRWoogeun Rhee
Woogeun Rhee
ZWZhihua Wang
Zhihua Wang
This paper describes a short-range transceiver architecture using frequency-hopped sinusoidal OOK pulses. Since signal bandwidth does not necessarily have to satisfy >500 MHz requirement like conventional ultra-wideband (UWB) pulses, the proposed transceiver named as a very-wide band (VWB) transceiver offers degrees of freedom to choose an optimum operation duty cycle in terms of energy efficiency, bandwidth efficiency, and communication range, while providing much lower operation duty cycle than that of narrow band OOK transceiver. The VWB transmission significantly relaxes the complexity of transceiver design without requiring advanced CMOS technology. In the transmitter, pulse generation circuit design is simplified with the duty-cycled sinusoidal signal compared to that in the impulse-radio UWB (IR-UWB) transmitter. In the receiver, an asynchronous energy detection topology is proposed to achieve robust energy detection by overcoming the synchronization issue as well as the saturation problem of the integrator circuit. A prototype 3-to-4 GHz VWB transceiver is implemented in 0.18 μm CMOS. The transceiver achieves the communication distance of >2 m at 1 Mb/s data rate with the peak-to-peak pulse amplitude of only 300 mV and the duty cycle of 0.6%, consuming 0.42 mW from a 1.8 V supply.

2 August 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
JLJianfu Lin
Jianfu Lin
ZSZheng Song
Zheng Song
NQNan Qi
Nan Qi
WRWoogeun Rhee
Woogeun Rhee
ZWZhihua Wang
Zhihua Wang
BCBaoyong Chi
Baoyong Chi
A 77-GHz frequency-modulated continuous-wave (FMCW) signal generator is presented for automobile millimeter-wave (mm-wave) radar applications. The reconfigurable chirp is generated by a mixed-mode synthesizer operating at 38.5 GHz, in which the frequency doubling scheme is used to improve the chirp bandwidth and simplify the design. The bang-bang phase detector (BBPD) is employed for phase detection in the synthesizer, avoiding complicated linear time-to-digital converter (TDC) as well as reducing design complexity and power consumption. A 1-bit third-order single-loop ΔΣ modulator (SLDSM3), combining with the hybrid finite-impulse-response (FIR) filtering technique, significantly suppresses the BBPD induced quantization noise. A type-III slope estimator with a switchable polarity is embedded in the digital loop filter (DLF) to improve the linearity around the chirp turning-around points (TAPs). Two infinite-impulse-response (IIR) filtering stages smoothen the generated chirp waveform by reducing the instant variation of the DLF's output. Implemented in 65-nm CMOS, the proposed FMCW signal generator consumes 43.1-mW power and occupies 2-mm 2 die area, including testing pads. The measured phase noise from the 38.5-GHz carrier is -87.7 dBc/Hz at 1-MHz offset. The measured root-mean-square (rms) frequency errors of the generated triangle chirps over the 1-ms period are 189 and 336 kHz, with 0.914- and 1.827-GHz chirp bandwidth, respectively.

2 May 2008 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
WRWoogeun Rhee
Woogeun Rhee
KJKeith A. Jenkins
Keith A. Jenkins
JLJohn Liobe
John Liobe
HAHerschel Ainspan
Herschel Ainspan
This paper describes experimental approaches to analyze the effect of the substrate noise on phase-locked loop (PLL) performance. Spectral analysis considering noise transfer functions of the PLL is used to identify the substrate-noise sensitive components of the PLL. Analyzing the sidebands seen in a spectrum analyzer confirms the importance of knowing the PLL loop dynamics and noise transfer functions. It also leads to the conclusion that the PLL blocks other than the VCO can be more sensitive to substrate noise coupling, depending on the substrate noise frequency. Furthermore, the result shows that intermodulation near the reference clock frequency could be a dominant source of generating sidebands in fractional-N PLLs.

29 June 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
XXXinyu Xu
Xinyu Xu
ZWZixiang Wan
Zixiang Wan
WRWoogeun Rhee
Woogeun Rhee
ZWZhihua Wang
Zhihua Wang
This paper describes a bias-current-free fractional-N hybrid phase-locked loop (HPLL) architecture that does not use a charge pump (CP) or a linear time-to-digital converter (TDC). A hybrid loop control with a digital integral path and an analog proportional-gain path offers technology scalability as well as linear phase detection under a low supply voltage. The CP-less analog control path consists of a flip-flop phase detector (PD) and passive loop filters including a programmable notch filter. Unlike the TDC, the flip-flop PD has negligible contribution to the in-band phase noise over different supply voltages. To mitigate Δ Σ quantization noise and PD nonlinearity effects, an FIR-filtered Δ Σ modulation is employed for fractional division. The proposed fractional-N HPLL implemented in 65-nm CMOS operates with a 0.65-V supply except a 0.9-V digital/voltage-controlled oscillator (D/VCO), consuming 1.85 mW at 1.2 GHz. The phase noise of -97 dBc/Hz at 1-MHz offset frequency and the reference spur of -76 dBc with the programmable notch filter are achieved. The measured in-band fractional spur levels vary from -37 dBc to -58 dBc. The experimental results show that the proposed architecture is promising for low-voltage clock generation and modulation systems.