22 January 2024 in IEEE Transactions on Antennas and Propagation
In this paper, a reconfigurable reflectarray (RA) system which can steer reflected beam at two-dimensions based on liquid crystal (LC) technology at Ka band is proposed. In the RA system, an individually controlled RA unit is come up with and utilized to generate a 12×12 elements RA, a novelty bias network composed of metalized vias holes and driving lines are proposed and used to control each element independently, a Ka band standard horn antenna is offset 20° at H-plane as the primary feed. Then the manufactured RA model is checked for the reconfigurability with bias voltage under the microscope, then the model is measured that a continuous phase varying ability can be achieved. During the measurement of beam steering, far field patterns at E-plane from 0° to 35° are measured; and scanning at H-plane can cover from 0° to 40°; for the special beam direction φ a = 115°, θ a = 15°, a near field measurement is used and proves that the 2D beam scanning is possible. Then LC RA is applied as reconfigurable intelligent surface (RIS) in the simulated narrow street model, and the results show that it could indeed enhance the received power of electromagnetic waves. The innovation of this study is to propose a single controllable LC RA unit and a corresponding bias network composed of metallized vias and driving lines, thus each element in RA can be controlled to change reflection coefficient and beam steering of greater freedom with LC technology is achieved, which is a potential RIS and provides a possible solution for the beam scanning property.
28 February 2022 in IEEE Access
In this paper, a reconfigurable reflectarray (RA) with two-finger element composed of electrically biased liquid crystal (LC) at millimeter wave band is proposed. An orthogonal bias network is proposed and developed, which can result in changes in the equivalent relative permittivity of the liquid crystal, and reflection phase along direction $x$ and direction $y$ can be realized, thus beam steering at both E-plane and H-plane can be achieved. The LC RA is composed of 10 $\times $ 10 elements of 2-finger unit, a standard horn antenna is obliquely placed as feed, and radiation pattern is calculated by array synthesis and full wave simulation. It is found that beam scan at both E-plane and H-plane can be achieved. Compared with former researches of LC RA, this work introduces a simple scheme to achieve beam scan for LC RA at both E-plane and H-plane.
4 March 2025 in IEEE Transactions on Antennas and Propagation
A novel two-step iterative optimization method could be used in microwave and mm-wave bands for optimal topology of 2-D sparse multiple input multiple output (MIMO) arrays and an improved back-projection algorithm (IBPA) for near-range scenarios have been proposed to achieve high-resolution three-dimensional (3D) imaging. According to point spread functions (PSF), the array topology results from the proposed design method has superior performance on sidelobe level both in the interference region (IR) and non-interference region (NIR), and the obtained peak sidelobe levels (PSLs) are lower than the conventional topologies over 2 dB. The IBPA has weighting factors incorporated into its forward physical wave equations to improve accuracy of the model. The imaging capabilities of the proposed array and IBPA have been experimentally verified. The proposed array could further mitigate the artifact distribution in target image than conventional arrays which is consistent to theoretical analysis. The proposed IBPA could provide higher resolution and lower PSLs without increasing the computational complexity.
1 November 2026 in IEEE Transactions on Microwave Theory and Techniques