11 June 2018 in Applied Physics Letters
We used depth-resolved cathodoluminescence spectroscopy and surface photovoltage spectroscopy to measure the effects of near-surface plasma processing and neutron irradiation on native point defects in β-Ga2O3. The near-surface sensitivity and depth resolution of these optical techniques enabled us to identify spectral changes associated with removing or creating these defects, leading to identification of one oxygen vacancy-related and two gallium vacancy-related energy levels in the β-Ga2O3 bandgap. The combined near-surface detection and processing of Ga2O3 suggests an avenue for identifying the physical nature and reducing the density of native point defects in this and other semiconductors.
24 August 2020 in Applied Physics Letters
Plasma etching of p-type GaN creates n-type nitrogen vacancy (VN) defects at the etched surface, which can be detrimental to device performance. In mesa isolated diodes, etch damage on the sidewalls degrades the ideality factor and leakage current. A treatment was developed to recover both the ideality factor and leakage current, which uses UV/O3 treatment to oxidize the damaged layers followed by HF etching to remove them. The temperature dependent I–V measurement shows that the reverse leakage transport mechanism is dominated by Poole–Frenkel emission at room temperature through the etch-induced VN defect. Depth resolved cathodoluminescence confirms that the damage is limited to first several nanometers and is consistent with the VN defect.
27 July 2022 in IEEE Transactions on Electron Devices
Vertical power devices require significant attention to their edge termination designs to obtain higher breakdown voltages without substantial increase in ON-state resistance. A simple edge termination structure for a GaN p-n diode is proposed, comprising a full layer lightly doped p-type GaN region underneath the higher doped ${p} +\!+$ contact layer. A TCAD model of the device is developed, and removal of the portions of ${p}$ ++ cap outside of the device active area in simulations is shown to increase the device blocking voltage capability. It causes the depletion width to increase in the lightly doped p-type layer and allows it to act similar to a junction termination extension (JTE). These predictions are validated empirically, resulting in a 52% measured increase in breakdown capability after selective removal of the ${p}$ ++ cap. This simple edge termination technique can be formed with only a single low-energy nitrogen implant or etching procedure, greatly increasing its manufacturability over more complex structures. Design optimization studies are pursued in TCAD to determine optimal parameter values for further improving breakdown performance. It is shown that the proposed edge termination technique can be employed to produce future high voltage vertical GaN devices without a significant gain in ON-state resistance and with wide tolerance to process variations.
24 March 2021 in Journal of Electronic Materials
4 September 2017 in Applied Physics Letters
We used depth-resolved cathodoluminescence spectroscopy (DRCLS) to measure the nature and spatial distribution of native point defects at Zn- and O-polar ZnO interfaces with iridium oxide (IrOx) and their impact on Schottky barrier formation. IrOx and other metal oxides exhibit higher Schottky barriers than their pure metal counterparts, consistent with wider depletion regions and potentially useful for ohmic contacts to p-type semiconductors. DRCLS with I-V and 1/C2-V barrier height and carrier profile measurements showed high zinc vacancy VZn and CuZn defect densities that compensate free carrier densities, increase depletion widths, and form higher effective barriers than Ir/ZnO contacts. Zn-polar versus O-polar ZnO interfaces with IrOx exhibit 40% higher VZn + CuZn interface segregation and lower carrier densities within a wider depletion region, accounting for the significantly higher (0.89 vs. 0.67 eV) barrier heights. Both the depth of VZn density segregation and the Zn-deficient layer thickness measured microscopically match the depletion width and applied electric fields comparable to spontaneous polarization fields across similar layers displaying analogous defect segregation. These results account for the difference in polarity-dependent segregation due to the electric field-driven diffusion of native defects near ZnO interfaces.
1 June 2015 in APL Materials
We used depth-resolved cathodoluminescence spectroscopy and surface photovoltage spectroscopy to measure the densities, energy levels, and spatial distributions of zinc/magnesium cation and oxygen vacancies in isostructural, single-phase, non-polar MgxZn1−xO alloys over a wide (0 ≤ x ≤ 0.56) range. Within this wide range, both defect types exhibit strong Mg content-dependent surface segregation and pronounced bulk density minima corresponding to unit cell volume minima, which can inhibit defect formation due to electrostatic repulsion. Mg in ZnO significantly reduces native defect densities and their non-polar surface segregation, both major factors in carrier transport and doping of these oxide semiconductors.