Ahmed Muhammed Saeed

Ahmed Muhammed Saeed

Auto-generated profile, based on publicly available information

Ahmed Muhammed Saeed

Department of Chemistry, Faculty of Science, Al-Azhar University, Cairo, Egypt

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2020 in Carbohydrate Polymers
Verified
Journal Article
Closed access
AEAhmed S Elfeky
Ahmed S Elfeky
Salem S. SalemSalem S. Salem
Salem S. Salem
AEAhmed Shafek Elzaref
Ahmed Shafek Elzaref
MOMedhat E Owda
Medhat E Owda
HEHassan A Eladawy
Hassan A Eladawy
Amr FoudaAmr Fouda
Amr Fouda

1 November 2018 in Chemosphere
Verified
Journal Article
Closed access
Alaa FahmyAlaa Fahmy
Alaa Fahmy
AEAdham El-Zomrawy
Adham El-Zomrawy
ASAhmed M. Saeed
Ahmed M. Saeed
ASAhmed Z. Sayed
Ahmed Z. Sayed
MEMohamed A. Ezz El-Arab
Mohamed A. Ezz El-Arab
HSHassan A. Shehata
Hassan A. Shehata

10 August 2023 in Scientific Reports
Verified
Journal Article
Open access
PDF file
MKMahmoud Khalaf
Mahmoud Khalaf
ASAhmed M. Saeed
Ahmed M. Saeed
AAAhmed I. Ali
Ahmed I. Ali
EKElbadawy A. Kamoun
Elbadawy A. Kamoun
Alaa FahmyAlaa Fahmy
Alaa Fahmy
Designing and synthesis of cost-effective and improved methanol permeable and proton conductive membranes are the main challenges for preparation of polymeric electrolyte membrane (PEM). Herein, a cost-effective PEM membrane based on phosphorylated polyvinyl alcohol (PVA)-grafted-cellulose acetate (CA) was prepared by a solution-casting technique. Water and methanol uptakes of phosphorylated PVA/CA membranes were characterized as function with the molar ratio of CA. Additionally, structure and morphology of phosphorylated PVA/CA (Ph-PVA/CA) membranes were verified by FT-IR analysis, SEM investigation. Furthermore, ion exchange capacity (IEC), proton conductivity and methanol permeation of Ph-PVA/CA membranes were examined based on the concentration of OPA basically. The results manifested a perceptible improvement in proton conductivity from 0.035 to 0.05 S/cm at 25 and 70 °C, respectively using 600 μL of OPA, and IEC of 2.1 meq/g using 400 μL of OPA at ambient temperature. On the other hand, methanol permeability (P = 1.08 × 10–10 cm2/s) was lower than Nafion 117 admirably. The optimum OPA concentration was 200 μL according to conductivity measurements (at 10% PVA, 150 μL GA, and CA 7%). Finally, prepared Ph-PVA/CA membranes exhibited enhancement in critical natures such as proton conductivity and IEC combined with its low-cost materials, which make them excellent candidate as PEM for DMFCs application.

14 February 2020 in Plasma Research Express
Verified
Journal Article
Closed access
Alaa FahmyAlaa Fahmy
Alaa Fahmy
AEAdham El-Zomrawy
Adham El-Zomrawy
ASAhmed M Saeed
Ahmed M Saeed
ASAhmed Z Sayed
Ahmed Z Sayed
MEMohamed A Ezz El-Arab
Mohamed A Ezz El-Arab
JFJörg Friedrich
Jörg Friedrich
Decolorization of Acid Orange 142 (AO142) as important water pollutant was observed on the exposure of the dye solutions to an atmospheric non-thermal gas plasma. A response surface methodology (RSM) combined with a central composite design (CCD) was utilized to optimize the main factors (variables) affecting the degradation efficiency (response) of AO142, such as the applied voltage, the gap distance between the high voltage electrode and the surface of the solution. The regression analysis showed that a first-order polynomial model well fits the experimental data with a coefficient of determination R 2 = 0.96. FT-IR, UV-vis, TOC and GC-MS measurements were used to investigate the decolorization of the dye on exposure to the plasma discharges. A possible degradation pathway was postulated. Additionally, the conductivity and pH changes during the treatment were also evaluated. The plasma treatment combined with Fe 2+ (plasma Fenton reaction) exhibited a higher degradation efficiency, higher energy yield connected with lower energy consumption in comparison to the plasma treatment without Fe 2+ addition.

21 November 2016 in Journal of Adhesion Science and Technology
Verified
Journal Article
Closed access
Alaa FahmyAlaa Fahmy
Alaa Fahmy
AEAdham El-Zomrawy
Adham El-Zomrawy
ASAhmed M. Saeed
Ahmed M. Saeed
ASAhmed Z. Sayed
Ahmed Z. Sayed
MEMohamed Alaa Ezz El-Arab
Mohamed Alaa Ezz El-Arab
JFJörg Friedrich
Jörg Friedrich
Silver nanoparticles (Ag NPs) embedded and stabilized with polyethylene glycol (PEG) were synthesized as colloids by heating and exposure to sunlight (direct and indirect) irradiation as green method. The deposition of Ag NP-PEGs onto Si-wafers was also made using the electrospray ionization deposition technique. The generating of Ag NP-PEGs as colloids was examined by UV–visible spectroscopy (UV–Vis) and transmission electron microscopy (TEM). The chemical composition of the resulted nanocomposites was evaluated by Fourier transform infrared (FTIR) and that of thin-film surfaces by X-ray photoelectron spectroscopy. Structure–property relationships of Ag-PEG nanocomposites prepared by heating were discussed in dependence on the time of heating. The UV–visible results confirmed the successful synthesis of spherical Ag NPs with absorption peaks at a wavelength of λ = 413 nm for the heating method and at λ = 418 as well as 449 nm for direct and indirect exposure to the sunlight. Ag-PEG nanocomposite thin films showed excellent antimicrobial activity. These results revealed that the Ag-PEG nanocomposites thin films can be used as potential materials in biomedical applications.

29 December 2022 in Materials Chemistry and Physics
Verified
Journal Article
Closed access
Alaa FahmyAlaa Fahmy
Alaa Fahmy
ASAhmed M. Saeed
Ahmed M. Saeed
UDUsama Dawood
Usama Dawood
HAHassan Abdelbary
Hassan Abdelbary
KAKorinna Altmann
Korinna Altmann
ASAndreas Schönhals
Andreas Schönhals