The present study reports the feasibility of the synthesis of a novel porous composite adsorbent, prepared from olive stone activated carbon (OS400) and garnet (GA) mineral impregnations (referred to as OSMG). This composite (OSMG) was applied for its ability to adsorb a macromolecular organic dye. The composite’s structural characteristics were evaluated using various techniques such as Brunauer–Emmett–Teller (BET), Scanning Electron Microscopy equipped with Energy Dispersive X-ray spectroscopy (SEM–EDX), X-ray diffraction (XRD), and a Fourier transform infrared spectrometer (FT-IR). The specific surface area of the garnet (GA), (OS400), and (OSMG) were found to be 5.157 mg⋅g−1, 1489.598 mg⋅g−1, and 546.392 mg⋅g−1, respectively. The specific surface area of the new composite (OSMG) was promoted to enhance the adsorption of methylene blue (MB). Experiments were conducted under various conditions, including contact time, initial dye concentration, adsorbent dosage, pH, and temperatures. Data from these experiments were analyzed using several adsorption models including Langmuir, Freundlich, Temkin, and Dubinin-Radushkevich (D-R). The results indicated that, the adsorption fit best with the Freundlich model and that the adsorption process followed a pseudo-second-order kinetic mechanism. Additionally, the thermodynamic analysis indicated the adsorption of MB onto garnet(GA) adsorbents is endothermic, while the sorption onto (OS400) and (OSMG) is an exothermic and non-spontaneous process. The OSMG composite can be used for at least five cycles without significant loss of adsorptive performance, and can easily be separated from the water after treatment.
9 May 2019 in Zeitschrift für Physikalische Chemie
The adsorption process of methylene blue (MB) and its removal from aqueous solution at initial pollutant concentration range of 1–7 ppm was investigated. Zeolite-A (Z) and its ZnO-loaded species (Z/ZnO) were prepared via microwave technique from natural resource and applied for dye removal. The loading of ZnO was governed by the cation exchange property of zeolite, followed by calcination. Experimentally, Z and Z/ZnO were tested using X-ray Diffraction (XRD), Fourier-Transform Infrared (FTIR), Scanning Electron Microscope (SEM), Energy Dispersive X-ray Spectroscopy (EDX) and N 2 adsorption-desorption. The examined parameters such as concentration of dye, contact time, ZnO dose and solution pH were traversed. Three isothermal models were analyzed. Kinetic studies indicated that, the adsorption of MB matched with pseudo-second order model. The maximum removal efficiency at pH 3, increased from 67.8% for Z to 94.8% for Z/ZnO modified with 3% ZnO loads (Z/ZnO (3%) ). Parameters such as ΔH, ΔS, ΔG, S* and Ea were thermodynamically calculated. Langmiur isotherm and pseudo-second order models were the best fitting for the obtained data. The results indicated that, the adsorption of MB dye is spontaneous and endothermic, the removal efficiency is favored by increasing the temperature. ZnO-zeolite has much higher adsorption capacity for eliminating MB dye than that of the un-loaded zeolite.
23 October 2021 in Environmental Science and Pollution Research
This investigation focuses on examining the adsorption behavior of crystal violet dye on cellulose (CS) and its modified forms, including cellulose loaded with nicotinic acid (CSN) and cellulose loaded with thiourea (CST). Batch experiments were performed to analyze the adsorption process, while various characterization techniques, such as Fourier-transform infrared spectroscopy (FTIR), X-ray diffraction analysis (XRD), Brunauer–Emmett–Teller (BET), scanning electron microscopy (SEM), and thermogravimetric analysis (TGA), were utilized to assess the structural and morphological changes in the cellulose materials. The findings reveal that the adsorption process follows a pseudo-second-order kinetic model, indicating a chemical adsorption mechanism. Additionally, the Langmuir isotherm model suggests monolayer adsorption on cellulose surfaces. Thermodynamic analysis demonstrates that the adsorption process is spontaneous and exothermic for CS and CSN, whereas it is endothermic for CST. The characterization techniques employed provide valuable insights into the structural modifications and porous properties of cellulose materials. Overall, this study underscores the potential of modified cellulose materials to effectively remove dyes in wastewater treatment applications. Notably, thiourea-loaded cellulose CST exhibits superior adsorption capacity with removal percentages of 78.2% compared to CS and CSN, whose removal percentages were 76.45% and 76.72%, respectively, suggesting the promising role of CST in dye removal. These findings contribute to a comprehensive understanding of crystal violet dye adsorption on cellulose and its modified forms, thereby paving the way for future research on the application of modified cellulose materials in wastewater treatment processes.
14 May 2024 in Journal of Photochemistry and Photobiology A: Chemistry