Andrea Riva

Andrea Riva

Auto-generated profile, based on publicly available information

Andrea Riva

Politecnico di Milano, Department of Mechanical Engineering, Via Giuseppe La Masa 1, 20156 Milan, Italy

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 January 2026 in Tribology International
Verified
Journal Article
Closed access
ABAlberto Betti
Alberto Betti
ARAndrea Riva
Andrea Riva
PFPaola Forte
Paola Forte
Steven ChattertonSteven Chatterton
Steven Chatterton
Enrico CiulliEnrico Ciulli
Enrico Ciulli


11 November 2026 in Journal of Dynamics, Monitoring and Diagnostics
Verified
Journal Article
Closed access
Paolo PennacchiPaolo Pennacchi
Paolo Pennacchi
Steven ChattertonSteven Chatterton
Steven Chatterton
AVAndrea Vania
Andrea Vania
LDLudovico Dassi
Ludovico Dassi
ARAndrea Riva
Andrea Riva
In large two-pole power generators, the anisotropy of the active part of the rotor causes twice per revolution (2X) vibrations whose amplitude depends on the rotational speed. When the speed approaches half the first critical bending speed, the so-called 2X resonance is excited. At such low speeds, the damping provided by oil-film journal bearings is often quite low and 2X vibration levels can become considerable. In generators mounted on only two main supports, a long and slender overhang shaft of the exciter can amplify this phenomenon, as its significant bending enhances the dynamic deflection at the midspan of the rotor. This paper investigates the beneficial effects of installing an additional oil-film journal bearing at the end of the overhang shaft of the exciter. A finite element model of a 600 MVA generator, whose equations of motion have been integrated in the time domain, was used to simulate the 1X and 2X vibrations accounting for the speed-dependent properties of the journal bearings and the periodic variations of the bending stiffness of the shaft. The numerical predictions are validated against experimental vibration data collected during speed transients before and after the installation of the additional support. Both experimental and numerical results demonstrate that the additional bearing significantly reduces the peak of the 2X vibration that occur at the main supports. Conflict of Interest Statement The authors declare no conflicts of interest.