Wear is one of the most common failures of hydrodynamic bearings. The main purpose of the present work was to investigate the effects of wear on lubrication performance and acquire efficient vibration signatures for fault diagnosis. In this paper, a finite element model (FEM) for a two-disk rotor supported on worn hydrodynamic bearings is presented in which the oil film force is evaluated by linear and nonlinear models. Numerical and experimental results indicate that the static and dynamic characteristics of the bearing are significantly changed by wear, leading to a drop in system critical speeds due to the deterioration of the constraint status provided by the bearings to the rotor. As the wear depth increases, the onset speed of oil whirl increases, while that of oil whip becomes lower, and large amplitudes of resonance and oil whip are more likely to be excited. More notably, all of the above vibration signatures in the y-direction are more sensitive to wear compared to those in the x-direction, which means that wear faults can be diagnosed by differences in vibration characteristics between the x- and y-directions. This research can provide a theoretical foundation and engineering guidance for the hydrodynamic bearing wear fault diagnosis.
Nonlinear vibration phenomena, such as oil whirl and oil whip, are common indicators of oil film instability in hydrodynamic bearings and are key signs of potential faults in rotating machinery. Excessive vibrations caused by oil film instability can accelerate bearing wear and lead to the failure of the rotating system. This paper presents a model for nonlinear dynamic coefficients, aimed at providing a quantitative approach for monitoring and predicting oil film instability. The impact of operational parameters and perturbation values on both linear and nonlinear stiffness and damping coefficients is investigated. Simulation results and experimental rotor vibration signals demonstrate that the nonlinear dynamic coefficient model effectively characterizes oil film instability and accurately predicts rotor trajectory, while traditional linear models are only applicable under low-speed and small-disturbance conditions. Compared to traditional analytical models and numerical solutions, the nonlinear dynamic coefficients have higher accuracy and efficiency and can reliably identify the onset frequency of oil film instability. This study clarifies the relationship between nonlinear dynamic coefficients and rotor dynamic response, laying a theoretical foundation for the monitoring and prediction of oil film instability.
Traditional non-coplanar calibration methods, represented by Tsai’s method, are difficult to apply in multi-camera-based stereo vision measurements because of insufficient calibration accuracy, inconvenient operation, etc. Based on projective theory and matrix transformation theory, a novel mathematical model is established to characterize the transformation from targets’ 3D affine coordinates to cameras’ image coordinates. Then, novel non-coplanar calibration methods for both monocular and binocular camera systems are proposed in this paper. To further improve the stability and accuracy of calibration methods, a novel circular feature points extraction method based on region Otsu algorithm and radial section scanning method is proposed to precisely extract the circular feature points. Experiments verify that our novel calibration methods are easy to operate, and have better accuracy than several classical methods, including Tsai’s and Zhang’s methods. Intrinsic and extrinsic parameters of multi-camera-systems can be calibrated simultaneously by our methods. Our novel circular feature points extraction algorithm is stable, and with high precision can effectively improve calibration accuracy for coplanar and non-coplanar methods. Real stereo measurement experiments demonstrate that the proposed calibration method and feature extraction method have high accuracy and stability, and can further serve for complicated shape and deformation measurements, for instance, stereo-DIC measurements, etc.