1 August 2024 in Review of Scientific Instruments
Efficient thermal management is essential for low-temperature optoelectronic devices. Traditional liquid nitrogen (LN2) cooling presents challenges such as frequent replenishment needs and limited operational duration. This study introduces micromachined Joule–Thomson (MJT) cooling as a superior alternative for temperature regulation in optoelectronic devices. We evaluated the thermal and optical performance of MJT cooling for a CdSe/ZnS quantum dot (QD) sample within a temperature range of 120–300 K. Thermal analysis showed that with a single 50 l nitrogen refill, the MJT system can operate continuously for over one week, surpassing the LN2 system by 11 times. The temperature stability was affected little by laser irradiation, with a <0.2 K rise at 5 mW of laser power. In addition, the MJT cooling led to an average blueshift of 1–3 meV in the emission peak of QDs and 0.3–2.3 meV reduced spectral broadening compared to LN2, attributed to a smaller sample-to-cold-stage temperature gap of about 8–9 K in the MJT setup. The standard deviations of peak energy and FWHM are in the order of E − 1 meV magnitude, demonstrating a comparable thermal uniformity compared to LN2. The vibration spectra obtained for both vertical and horizontal directions reveal the superior low-vibration characteristics of MJT cooling. These findings validate MJT cooling as a superior and reliable strategy for the thermal management of optoelectronics, ensuring prolonged operational durations, reliable temperature stability, enhanced temperature precision, high thermal homogeneity, and low vibrations.
15 January 2024 in Research Square
Van der Waals integration enables the creation of electronic and optoelectronic devices with unprecedented performance and novel functionalities beyond the existing material limitations. However, it is typically realized using a physical pick-up-and-place process to minimize interfacial damages and is hardly integrated into conventional lithography and metallization procedures. Here we demonstrate a simple and ultra-clean in situ transfer strategy for van der Waals integration, in which a thin film of amorphous water ice acts as a buffer layer to shield against the bombardment of energetic clusters during metallization. After ice sublimation, the deposited metal film can be gently and in situ placed onto underlying substrates, e.g., 2D semiconductors, to form an atomically clean and damage-free metal-semiconductor interface. We use this strategy to demonstrate the non-destructive fabrication of high-quality contacts on monolayer MoS 2 , which is extremely beneficial to produce a high-performance 2D field-effect transistor with an ultra-high on/off ratio of 10 10 , mobility of 80 ( cm 2 V -1 s -1 ), and also with reduced Fermi level pinning effect. Benefiting from the chemical residue-free and gentle fabrication approach, this strategy could also widen the existing range of materials for vdW integration. Our method can be easily integrated with mature semiconductor manufacturing technology and may become a generic strategy for fabricating van der Waals contacted devices.