26 July 2022 in IEEE Transactions on Industrial Electronics
In this article, a multiplexed active clamp high-frequency link inverter (MACHFLI) with de–re-coupling frequency doubling modulation (DFDM) is proposed. The proposed MACHFLI consists of a primary inverter, a high-frequency transformer, a multiplexed active clamp (MAC) circuit, and a cycloconverter. The MAC recycles leakage inductance energy and eliminates voltage spikes caused by leakage inductance. Overlapping commutation is designed in the DFDM to ensure the safe commutation of the output filter inductor current and realize the zero-voltage switching (ZVS) of the cycloconverter. The ZVS of the primary inverter can be realized utilizing magnetizing current, and the full-range ZVS of MAC can also be realized with turn- on delay. The operating principle and ZVS conditions of the proposed MACHFLI are analyzed, and the design of the transformer and clamp capacitor is discussed in this article. Finally, a 1-kW prototype is made to verify the analysis results. Experimental results show that MACHFLI has four-quadrant operation capability, good dynamic response, high efficiency over a wide load range, and its peak efficiency reaches 95.4%.
17 November 2023 in IEEE Transactions on Power Electronics
High switching frequency grid-connected converters are widely used in renewable energy generation, which is prone to cause serious broadband oscillation. The broadband impedance measurement device with low total harmonic distortion (THD) is an effective means to analyze the stability of grid-connected system. This article proposes a low-carrier-ratio model predictive control (LCR-MPC) for 100 kHz lager-signal multiphase converters with low THD. Compared to the conventional low-carrier-ratio methods with huge offline calculation burden, the proposed LCR-MPC can calculate the switching angles online with a low calculation burden. First, the fast selection of optimal state and the online calculation of initial switching angles are proposed. Then, a finite set of switching angles is constructed by the virtual carriers to meet constraints. The finite set is used by MPC for online calculation with low THD. Finally, the performance of LCR-MPC is verified by comparing simulation and experimental results with carrier phase shift pulsewidth modulation (CPS-PWM) and optimized pulse patterns for a six-phase converter. Compared with CPS-PWM, the average THD improvement of the proposed method is 4.45% at a carrier ratio of 6.