15 June 2025 in Optical Fiber Technology
20 April 2023 in Optics Express
We propose a novel optimization method that combines two design criteria to reduce the differential modal gain (DMG) in few-mode cladding-pumped erbium-doped fiber amplifiers (FM-EDFAs). In addition to the standard criterion that considers the mode intensity and dopant profile overlap, we introduce a second criterion that ensures that all doped regions have the same saturation behavior. With these two criteria, we define a figure-of-merit (FOM) that allows the design of FM-EDFAs with low DMG without high computational cost. We illustrate this method with the design of six-mode erbium-doped fibers (EDFs) for amplification over the C-Band targeting designs that are compatible with standard fabrication processes. The fibers have either a step-index or a staircase refractive index profile (RIP), with two ring-shaped erbium-doped regions in the core. With a staircase RIP, a fiber length of 29 m and 20 W of pump power injected in the cladding, our best design leads to a minimum gain of 22.6 dB while maintaining a DMGmax under 0.18 dB. We further show that the FOM optimization achieves a robust design with low DMG over a wide range of variations in signal power, pump power and fiber length.
7 December 2020 in IEEE Photonics Technology Letters
In this letter, we present the design and implementation of a wavelength tunable Q-switching fiber laser based on two-cascaded tunable filters; overlapping on transmission spectrum of both filters allows keeping the cavity losses at low level, while losing the overlapping condition increases the losses in the cavity. Following these two conditions, one tunable filter is used to select the wavelength emission of the laser; and the other tunable filter is used to actively switch on-off the overlapping condition along the range of tuning. Implementing this switching principle, pulses of light within 30 nanometers of tuning range are easily generated. Despite this range is limited by the Erbium-Ytterbium co-doped fiber implemented as the laser amplifier, the technique can be implemented at different wavelengths and ranges of emission using different doped fibers. Also, experimental characterization of the wavelength tunable pulsing laser is presented, pulsing emission at different wavelengths, time duration of pulses and average optical power as a function of wavelength, and time duration and peak power of pulses as a function of the switching rate.
23 December 2025 in Results in Optics
GNGaelle Carine Mbanda Nsoungui
Gaelle Carine Mbanda Nsoungui
+2
18 April 2024 in Optics Express
Producing high performance amplifiers requires accurate numerical models. As the optimization space is large, computationally efficient models are of great value. Parameter-based models for L-band amplifiers have accuracy limited by difficulty in estimating the Giles-parameter. The use a neural network model can avoid parametrization. We exploit a rich, experimentally captured training set to achieve a high accuracy neural network model. Our approach creates independent models for gain and noise figure. We examine both core and cladding pumping methods, again with independent models for each. The neural networks outperform parameter-based models with higher accuracy (variance of error reduced by 50%) and extremely fast simulation times (400 times faster), greatly facilitating amplifier design. As an example application, we design an amplifier to optimize optical signal-to-noise ratio by exhaustive search with our fast neural network models.