The tin oxide (SnO 2 )-graphene composite was synthesized by the in-liquid plasma method using SnO 2 nanoparticles (average diameter ~30 nm) dispersed ethanol as a precursor without providing external heat. As observed from scanning electron microscopy (SEM) and transmission electron microscopy (TEM), the SnO 2 nanoparticles were distributed uniformly on flaky graphene sheets. The formation of SnO 2 and high crystalline graphene was supported by the Raman analysis and x-ray diffraction (XRD) studies. A facile, low-cost method operating at atmospheric pressure based on the in-liquid plasma technology can be utilized to fabricate SnO 2 -graphene composite using minimum precursors for future applications such as gas sensing devices and fuel cells.
31 October 2022 in Journal of Vacuum Science & Technology A
A novel route to achieve an ideal plasma-enhanced atomic layer etching of silicon dioxide with self-limiting deposition and area-selective feature over silicon nitride is demonstrated in this work using a silane coupling agent and argon plasma. While monitoring the film thickness of silicon dioxide, self-limiting characteristics in both modification and etching steps are attained. Moreover, the dosing step revealed the selective formation of a modification layer on the oxide over the nitride film. In situ infrared spectroscopy results suggest the surface functionalization of the hydroxyl terminal groups of the oxide with the silane coupling agent to form the self-limiting modification layer at a relatively low substrate temperature. Compared to the previously reported fluorocarbon precursors, a higher etch yield for SiO2 was calculated, showing a promising option to meet the increasing demands in semiconductor production.
7 January 2019 in Japanese Journal of Applied Physics
Control of the bonding structure in carbon materials is achieved by a post-treatment of atmospheric pressure plasma (APP) for magnetron-sputtered carbon films. The APP post-treatment changes the films morphologically owing to the removal and modification of sp 2 bonds on the basis of the near edge X-ray absorption fine structure analysis of sp 2 contents. By APP post-treatment, the resulting changes in surface and bulk properties modify the optical and electrical properties of the carbon films. The control of the film properties can be utilized for various applications, such as gas sensors and solar cells.
13 August 2021 in IEEE Transactions on Plasma Science
Simple low-temperature pulsed power dissociation method for high resistive liquid is proposed in this article. Active high voltage rebound tailing pulse (RTP) diodes are adopted to conventional high voltage pulse power sources. In order to explain this method, the study was performed using deionized water (DIW) (high resistive > 17 MΩ · cm) electrolysis with two immersed electrodes. The forward pulses, the full-width at half-maximum (FWHM) of 400 ns and forward voltage (7 kV) with rising-up ratio (dV/dt) of 10¹¹ V/s, were applied to the electrodes. When a 5 kV RTP diode was simply adopted to this electrical circuit and DIW load in series, the high forward voltage pulse and continuous high reverse current were applied to this circuit. Then, H₂ was generated at the anode electrode and OH radical (OH) in the water vessel. Those phenomena were apparently dependent on the anode electrode area. At the beginning of the forwarded high voltage application, the circuit behaved as capacitance load with generated ions and built up charges at the interface between DIW and the electrode. Continuous rebounded high reverse voltage and highly built-up reverse recovery charges induce avalanche breakdown of RTP diode. The rebounded electrical current was found to be collected in the circuit, accompanied by the generation of hydrogen and OH, as well as the tailing current flowing at the interface as a resistive load. In consequence, we point out that rebounded electrons injected from the surrounding water to the anode electrode interface induced the water electrolysis characteristically, according to RTP-diode inserted in the circuit.