Ki Yong Son

Ki Yong Son

Auto-generated profile, based on publicly available information

Ki Yong Son

Samsung Electronics Company Ltd., Hwaseong 443-742, South Korea

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 September 2018 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
KKKuduck Kwon
Kuduck Kwon
SKSinyoung Kim
Sinyoung Kim
KSKi Yong Son
Ki Yong Son
A hybrid transformer-based CMOS tunable duplexer with a single-ended blocker-tolerant low-noise amplifier (LNA) is proposed for a highly integrated reconfigurable RF front-end architecture. The proposed LNA adopts Q-enhanced LC notch filter at the source of the cascode device and LC bandpass filter at the load. It improves the blocker tolerance and linearity of the receiver by rejecting unwanted out-of-band blockers and transmitter (TX) leakage signals. The duplexer with the notch-filtered LNA was fabricated in a 65-nm CMOS process. It has a voltage gain of 24.2 dB from the antenna to the LNA output with 28-dB notch filtering, cascaded noise figure of 6.4 dB, TX insertion loss of 3.8 dB, and IIP3FD of 52.4 dBm. It can also cover a mid-band range from 1.6 to 2.2 GHz in cellular applications. It draws an average current of 8 mA from a supply voltage of 1.2 V and has an active area of 1.19 mm 2 .

20 June 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
KSKi Yong Son
Ki Yong Son
TKTaejong Kim
Taejong Kim
KKKuduck Kwon
Kuduck Kwon
A dual-band CMOS duplexer employing a switchable autotransformer is proposed for highly integrated RF front ends in mobile phones. Because on-chip switches are used to change the length of the autotransformer, the inductance is sized for two different frequency ranges. It is designed to support both low-band (LB) mode from 0.7 to 0.9 GHz and mid-band (MB) mode from 1.7 to 2.0 GHz for cellular applications. With different inductances for LB and MB modes, transmitter (TX)-to-receiver (RX) isolation is achieved by using two separate balance networks for LB and MB. The duplexer is implemented in a 65 nm CMOS process. In LB mode, TX and RX insertion losses (ILs) are less than 4.3 dB, while TX-to-RX isolation is more than 50 dB. In MB mode, TX IL and RX IL are less than 4.5 dB, while TX-to-RX isolation is more than 50 dB. The proposed duplexer proves feasible structure to cover both LB and MB frequency ranges in cellular 3G/4G applications.