31 July 2012 in RSC Advances
A new anatase/rutile TiO2 nanocomposite microspheres (ART) electrode with hierarchically porous structures was successfully synthesized by a one-step route under mild hydrothermal conditions. The morphology, crystal structure and phase composition, specific surface area and pore size distribution of the obtained nanocomposite were systematically investigated by X-ray diffraction (XRD), Raman spectroscopy, field-emission scanning electron microscopy (FESEM), high resolution transmission electron microscopy (HRTEM) and nitrogen adsorption–desorption measurements. The as-synthesized nanocomposite microspheres electrodes exhibited superior specific capacity and high-rate charge–discharge performance for lithium-ion batteries (LIBs) (∼103 mA h g−1 at 30 C after 100 charge–discharge cycles, 1 C = 170 mA g−1) as compared to commercial TiO2 nanoparticles (P25). The improvement is mainly attributed to enhanced Li-ion diffusion and efficient charge transport as evidenced from cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) measurements. Most importantly, the materials architecture used in this study, comprising of dual-phase TiO2 nanocrystals with hierarchically porous structures would be a general concept that could be applicable in the development of other mixed-phase electrode materials for rechargeable lithium-ion batteries and supercapacitors.
12 July 2022 in Energy & Environmental Science
Heterostructure construction, especially for anodes, is an effective strategy to promote electron transfer and improve surface reaction dynamics, thus achieving high performance in lithium-ion batteries. Herein, in situ partial conversion of metal sulfide to oxide with high lattice match is utilized to engineer a ZnO/ZnS heterostructure. The mosaic ZnO/ZnS heterostructure with abundant interfaces is activated into homogeneous zinc oxysulfide with size optimization during cycling, which delivers 920 mA h g−1 after 1300 cycles even at 2 A g−1. A pouch-type full cell (LiCoO2‖ZnO/ZnS) is assembled and maintains over 85% of its initial capacity after 300 cycles at 2C, confirming its potential practicability. Theoretical calculations predict that, combined with LiZn nanodots, the Li2O/Li2S matrix is endowed with more Li anchoring sites and higher Li adsorption energy. Therefore, the interfacial charge redistribution is modified to contribute high interfacial Li storage. The reasonable interfacial engineering by designing a mosaic heterostructure breaks new grounds for the design of large-capacity and high-reversibility conversion-alloying-type anodes.
3 November 2017 in Journal of Materials Chemistry A
Ni/NiTiO 3 manifests remarkable catalytic performance for both the oxygen evolution reaction (OER) and the hydrogen evolution reaction (HER) in alkaline solutions.
30 April 2013 in Journal of Materials Chemistry A
Mass pure sandwich-like (hcp- and fcc-) Co/GE (graphene)/Co nanocomposites have been synthesized by direct ball-milling of Co and GE powders by adjusting the reaction conditions, and the maximum hydrogen storage capacity achieved was 899.5 mA h g−1 (3.29 wt% hydrogen).
29 November 2024 in Journal of the American Chemical Society
21 February 2013 in Inorganic Chemistry