23 January 2023 in NDT & E International
26 May 2020 in Smart Materials and Structures
This paper presents a novel flexible tactile sensor for triaxial force dynamic measurement based on piezoelectric elastomer. The piezoelectric elastomer is flexible composite of polyvinylidene fluoride (PVDF) terpolymer and polydimethylsiloxane (PDMS), and multi-wall carbon nanotubes (MWCNTs) are added into the elastomer to improve the piezoelectricity. The elastomer is placed under a PDMS bump and divided into four sensing units by attaching separated copper electrodes. Electrical charges generated by the sensing units are corresponding to the triaxial contact force and the amplitudes of the component forces in three directions could be obtained via the charge outputs of the proposed sensor. Prototype sensors were validated through dynamic tests and the results showed that the sensitivity of the sensor could be improved by adjusting the content of PVDF (10% to 30%) and MWCNTs (0% to 4%). Specifically, the sensitivity in normal direction would increase by 85% as the content of PVDF increases and increase by over 150% as the content of the MWCNTs increases. Accordingly, the sensitivity in shear direction would increase by 45% and 85%, respectively.
9 August 2021 in IEEE Sensors Journal
This paper proposes a novel flexible tactile sensor array for dynamic triaxial force measurement. Piezoresistive nanofibers, which are fabricated via the electrospinning method and are composed of multi-wall carbon nanotubes (MWCNTs) and thermoplastic polyurethane (TPU), are selected as the sensing material. The sensitive piezoresistive layer, which has micron-scale thickness, is wrapped in polydimethylsiloxane (PDMS) with a bumped surface. This structure not only detects triaxial forces of different magnitudes and frequencies, but also can recognize the shape, size, and curvature of external objects using multiple measuring points of the sensor. When the sensor is subjected to normal forces at different frequencies, the measuring voltage shows good responses with variations of less than 1.21 %. When the sensor is subjected to shear forces, the coefficient of variation is less than 2.05%. In addition, when the sensor is stressed at multiple measuring points, the voltage response errors between the different points are less than 5.29%. The sensor shows high sensitivity (with a resistance change that can reach four orders of magnitude) and high response-speeds (response within 62 ms) in validation experiments. The proposed flexible sensor is efficient in triaxial force detection and has the potential for application to prosthetic hands and wearable devices.
19 May 2023 in IEEE Transactions on Instrumentation and Measurement
Thermography is widely used to detect delamination defects in carbon fiber reinforced plastics (CFRP). This paper proposes a model to detect defects automatically by extracting the thermal signal characteristics of CFRP materials. An optically excited thermography system is constructed for pulsed and lock-in thermography experiments to compare thermal signal data sets in different excitation modes. A multi-task joint loss function is defined to train the model for defect detection and depth prediction. The effects of different attention modules (AM) are analyzed to improve the model performance. By comparing the effects of traditional thermography processing methods and methods based on Convolutional Neural Network (CNN), it is found that the proposed model can detect defects with minimum aspect ratio (ratio of short side to depth) of 2.5, and the relative error percentage in depth prediction is below 10%.
14 May 2019 in Applied Composite Materials
22 September 2025 in Carbon Letters