Masahiro Usui

Masahiro Usui

Auto-generated profile, based on publicly available information

Masahiro Usui

The University of Tokyo

Research Focus & Metrics

Academic Career Length

30Years (1997-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 September 2020 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Closed access
KSKota Shiba
Kota Shiba
TOTatsuo Omori
Tatsuo Omori
MUMasahiro Usui
Masahiro Usui
MHMototsugu Hamada
Mototsugu Hamada
TKTadahiro Kuroda
Tadahiro Kuroda
An area-efficient low-power wireless inductive coupling interface for a 3D-stacked high-bandwidth memory is presented. A test chip was fabricated in a 40-nm CMOS technology and 1.5-Gbps 2.2-pJ/bit communication using a 0.23-V NMOS push-pull transmitter and 7-μm multi-layer coils was experimentally confirmed. The low-voltage transmitter reduces power dissipation by 55% compared to the conventional one in measurement. The proposed 7-μm multi-layer coils improve their mutual inductance by a factor of 4.5 compared to that of conventional single-layer ones. This paper discusses the multi-layer coil wiring topology based on simulation and measurement. Optimization of the link budget achieves 7.1% power reduction compared to the conventional structure. Using this interface, a memory module consisting of eight 8-μm-thick memory dies and a base die in a 40-nm CMOS process and communicating at 3.6 Gbps is extrapolated to achieve a 2.3-Tbps/mm2 area efficiency and 6.1-pJ/bit energy efficiency. We also estimate that a 41-Tbps/mm2 0.1-pJ/bit memory interface is achievable in a 7-nm CMOS process.

1 January 1997 in IEEJ Transactions on Power and Energy
Verified
Journal Article
Open access
PDF file
MUMasahiro Usui
Masahiro Usui
SIShinichi Iwamoto
Shinichi Iwamoto
Network parameters in power systems are necessary to calculate bus voltages, currents, and powers. Therefore accuracy of network parameters is very important to get hold of the condition of power systems exactly. However generally, we regard them as constant. Thus accuracy of network parameters and calculated state values may be deteriorated. Recently, studies on Global Positioning System (GPS) for power system monitoring are being carried out in many fields. Because of high accuracy of GPS's time signals, we can calculate phase angles simultaneously from waveform of bus voltages or currents. By using this information, we can estimate more accurate network parameters and consequently state values. In this paper, we propose a new method of on-line network parameter and state estimations using phase angles which can be calculated by GPS and power system information (bus voltages, power flows, line flows). By doing the estimation, improvement in accuracy of network parameters and all sorts of calculations in power systems is expected.

19 January 2022 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
RMReiji Miura
Reiji Miura
SSSaito Shibata
Saito Shibata
MUMasahiro Usui
Masahiro Usui
KSKota Shiba
Kota Shiba
AKAtsutake Kosuge
Atsutake Kosuge
TKTadahiro Kuroda
Tadahiro Kuroda
This paper presents a bonding-less 5-GHz RFID tag module using an 85% downsized RFID tag chip and a 97% downsized antenna. Inductive (or magnetic) coupling between the antenna and the chip realizes low cost bonding-less implementation. Compared with a conventional module operating in the UHF band, the proposed module operating in the 5GHz range is downsized in terms of both the chip and the antenna sizes. The experimental results confirmed that the proposed RFID tag module successfully works at 20 cm away from a reader whose output power is 15 dBm, achieving the same figure of merit as a conventionally bonded module. Moreover, this paper confirmed that the misalignment tolerance of the inductive coupling can be up to 50 μm.