11 August 2023 in IEEE Sensors Journal
A calibration and measurement method based on an autocollimator and a manual turntable are proposed to calibrate the mounting error of a three-axis microelectromechanical system (MEMS) gyroscope in a wearable inertial measurement unit (IMU). In this system, with extension of the angle range of the autocollimator to ±9° and setting the mutual orthogonal structure of the two autocollimators, the measurement angle range of the MEMS gyroscope mounting error and the evaluation reference of the three-axis attitude angle data are obtained respectively, and the common data acquisition serial port between the autocollimator camera and the IMU host computer is built. As a result, the acquisition time is synchronized between the two systems. Additionally, the angular rate reading value of the MEMS gyroscope is integrated by time to unify the reading value scale between the calibration system and the MEMS gyroscope. This method is further compared with the traditional precision three-axis angular rate output turntable calibration method, and the accuracy deviation of the MEMS gyroscope mounting error after calibration is less than 0.3%. This method helps facilitate the development of inertial sensing calibration techniques toward traceability, which significantly reduces and simplifies laboratory equipment costs and maintenance requirements.
1 June 2025 in Journal of Optical Technology
Subject of study . Autocollimation measurement systems are the main means to realize precision angle measurement, but multifaceted error sources limit the further improvement of autocollimator angle measurement accuracy. The purpose of the work. This paper focuses on a kind of reflection noise induced from the non-working optical structure surface inside the autocollimator. This noise source can lead to errors in the detection of the target image by the image sensor. Method. Combined with the principle of Hough transform image recognition, we propose to utilize the Retinex theory to compensate the reflection noise inside the autocollimator. Main results. It is experimentally verified that this compensation algorithm can effectively suppress the influence of noise on imaging detection, and the measurement accuracy of the autocollimator around the X -axis and Y -axis can be improved from 4.29
′
′
and 3.87
′
′
to 3.59
′
′
and 3.15
′
′
. The system measurement stability performance is also improved, about 11.99% and 15.75% in the X -axis and Y -axis directions, as well. Practical significance. Therefore, this algorithmic compensation method can effectively enhance the measurement performance of the autocollimator.