16 February 2024 in IEEE Transactions on Electron Devices
Ultra wide bandgap semiconductor beta-gallium oxide ( $\beta$ -Ga $_{\text{2}}$ O $_{\text{3}}$ ) has the potential in fabricating the next generation of power devices applied at high temperature and high voltage due to its superior material properties and cost competitiveness. However, the performance of the existing $\beta$ -Ga $_{\text{2}}$ O $_{\text{3}}$ power diodes is far from the theoretical value because of the restriction of interface quality and edge electric field crowding effect. In this review, we introduce several effective interface engineering and edge termination techniques commonly used in vertical $\beta$ -Ga $_{\text{2}}$ O $_{\text{3}}$ diodes, highlighting their design principles, key fabrication processes, physical mechanism, and merit/demerit. To realize the actual applications, the representative large-size $\beta$ -Ga $_{\text{2}}$ O $_{\text{3}}$ diodes that can allow large level current to flow are also discussed. In addition, possible optimization strategies for these techniques are proposed for researchers’ reference. This article will help researchers understand the current study status of vertical $\beta$ -Ga $_{\text{2}}$ O $_{\text{3}}$ diodes and inspire researchers for future innovation in this emerging and exciting field. Moreover, the techniques and optimization strategies mentioned can also be applied to other semiconductors.
14 October 2024 in Applied Physics Letters
This work investigated the single-event effects (SEE) of NiO/β-Ga2O3 heterojunction diodes (HJDs) irradiated by 1.86 GeV tantalum ions with linear energy transfer over 80 MeV cm2/mg. The HJDs exhibited radiation responses with the early single-event leakage current (SELC) degradation until the fatal single-event burnout (SEB) failure, which was far below their breakdown voltages. Meanwhile, the surface morphology revealed the SELC damage expressed as burnout of topside NiO and metal stacks, while the SEB damage was observed as a burned hole in the β-Ga2O3 epitaxial layer. According to technology computer aided design simulations, the thicker p-type region in HJDs could further alleviate the electric field crowding effect exacerbated by the heavy-ion strike because of the extension of charge distribution in the p-type region. The SEB threshold was raised to 250 V by thickening the NiO layer to 300 nm. As for the SELC degradation process along with the burnout of topside stacks in HJDs, we supposed the probable reason was the intolerance of NiO to the high electric field under the SEE. This paper analyzed the SEE mechanism in β-Ga2O3 diodes and paved the way for heavy-ion irradiation hardening.
26 February 2026 in IEEE Electron Device Letters
Schottky Barrier Diodes (SBDs) made of ultra-wide-bandgap $\beta $ -Ga2O3 boast high Baliga Figure-of-Merit, but the premature breakdown induced by surface killer defects hinders the scale-up of device area, and therefore, the current rating. In this work, we demonstrate that Ar plasma treatment effectively reduces the density of surface killer defects, leading to more uniform performance in small-area SBDs. The improved uniformity at small scale provides a reliable foundation for scaling to large-area devices. Based on this approach combined with oxygen annealing, we fabricated $\beta $ -Ga2O3 SBDs with a $3\times 3$ mm2 active area and a composite p-NiO/BaTiO3 edge termination. The devices exhibit breakdown voltages exceeding 2 kV and sustain a high ON-current of 16 A at 2 V forward bias at room temperature, while maintaining a breakdown voltage above 1.8 kV and an ON-current of 13.7 A at 2 V even at 450 K. These results highlight the dual benefits of plasma defect suppression in achieving both device uniformity and robust large-area capability, underscoring the promise of $\beta $ -Ga2O3 SBDs for high-power applications.
27 February 2026 in IEEE Transactions on Electron Devices
Beta-gallium oxide ( $\beta $ -Ga2O3) power diodes have the potential in applications at high-temperature and high-voltage environments. The Nickel oxide (NiO)-based junction termination extension (JTE) can prevent the diodes’ premature breakdown, fully leveraging the high ${E} _{\text {C}}$ of $\beta $ -Ga2O3. However, the reliability of $\beta $ -Ga2O3 Schottky barrier diode (SBD) featuring JTE under high-temperature storage stress (HTSS) warrants attention. In this study, a HTSS test at $250~^{\circ }$ C was conducted on JTE-SBD and the changes in device performance over the storage time were investigated. During the test, the turn-on voltage ( ${V} _{\text {on}}$ ) of diodes increased from 0.90 to 1.10 V, while the breakdown voltage (BV) showed a phenomenon of first increasing and then decreasing. The $C$ – $V$ measurements shows that the carrier concentration ( ${N} _{\text {A}}$ ) of NiO initially decreases and subsequently increases, leading to the variations of the peak electric field. To enhance the device reliability, an oxygen annealing process has been proposed. By this approach, the ${V} _{\text {on}}$ of JTE-SBD only increased 0.10 V during the test. Due to the lower and more stable ${N} _{\text {A}}$ of NiO, the average BV of the annealed JTE-SBD maintained 2231 V even after 124h HTSS. Finally, X-ray photoelectron spectroscopy (XPS) spectra illustrate the reasons for the changes of ${N} _{\text {A}}$ of NiO. This study enhances the understanding of the reliability of $\beta $ -Ga2O3 and NiO, providing effective strategy for improving the stability of NiO/ $\beta $ -Ga2O3 JTE-SBD.
26 December 2025 in IEEE Transactions on Nuclear Science
This work investigates the alpha-particle detection performance of a p-NiO/β-Ga2O3 heterojunction diode (HJD) detector at elevated temperatures reaching 625 K and assesses its long-term operational robustness at 575 K. This HJD detector demonstrates a minimal reverse leakage current of 60 pA at -450 V, predominantly influenced by Poole-Frenkel (PF) emission. Capacitance-frequency analysis confirms a low density of trap states at the interface. The detector achieves an energy resolution of 3.19% at room temperature under -450 V. During heating tests at -100 V, the resolution improves from 6.1% to below 5%, due to a reduction in the energy required for electron-hole pair generation (ɛe-h). This result indicates that β-Ga2O3 offers a considerably greater temperature dependency of ɛe-h relative to SiC, potentially augmenting high-temperature signal amplitude greatly. Furthermore, the detector also exhibits strong operational reliability over 100 hours of continuous testing at 525 K. These findings underscore the efficacy of β-Ga2O3-based detectors for dependable radiation detection under elevated temperature conditions.
1 September 2026 in IEEE Transactions on Electron Devices