Yu-Chen Chang

Yu-Chen Chang

Auto-generated profile, based on publicly available information

Yu-Chen Chang

Department of Electronic and Computer Engineering, National Taiwan University of Science and Technology, Taipei 106, Taiwan

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 November 2022 in Energies
Verified
Journal Article
Open access
PDF file
MTMarek Turzynski
Marek Turzynski
SBSerafin Bachman
Serafin Bachman
MJMarek Jasinski
Marek Jasinski
SPSzymon PIASECKI
Szymon PIASECKI
MRMarek Ryłko
Marek Ryłko
YCYu-Chen Chang
Yu-Chen Chang
Micro-grid solutions around the world rely on the operation of DC/DC power conversion systems. The most commonly used solution for these topologies is the use of a dual active bridge (DAB) converter. Increasing the efficiency and reliability of this system contributes to the improvement in the stability of the entire microgrid. This paper discussed an analytical method of energy efficiency and power loss estimation in a single phase dual active bridge (DAB) converter controlled with a single-phase shift (SPS) modulation scheme for microgrid system stability. The presented approach uses conduction and commutation losses of semiconductors and high frequency transformer. All parameters required for the calculation may be obtained from the manufacturers’ datasheets or can be based on a simple measurement. The approach was validated by the comparison of the estimated energy efficiency characteristics with the measured ones for a prototype of a 5 kW single phase DAB converter equipped with silicon carbide metal-oxide semiconductor field-effect transistors (SiC MOSFET).

10 January 2024 in Energies
Verified
Journal Article
Open access
PDF file
SKShihhao Kuo
Shihhao Kuo
HUANG-JEN CHIUHUANG-JEN CHIU
HUANG-JEN CHIU
CCChe-Wei Chiang
Che-Wei Chiang
THTa-Wei Huang
Ta-Wei Huang
YCYu-Chen Chang
Yu-Chen Chang
MTMarek Turzynski
Marek Turzynski
An optimal modulation scheme with triple-phase-shift (TPS) control could increase the efficiency in the entire load range for a dual-active-bridge (DAB) converter under wide output voltage range conditions. Therefore, this study proposes a convergent approach to TPS mode selection, coupled with an optimal modulation scheme, ensuring the circuit’s efficiency over the entire range in the realm of a high-power and high-efficiency battery charger for electric vehicles. The convergent approach to TPS mode selection also reduces the numerous cases for small-signal analysis through general average modeling. After verifying the small-signal models under various voltage transfer ratios and load conditions to verify the stability, a converter prototype with a rated power of 15 kW is built and tested. Thus, a peak efficiency of 97.7% can be achieved.

5 June 2023 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
THTa-Wei Huang
Ta-Wei Huang
HUANG-JEN CHIUHUANG-JEN CHIU
HUANG-JEN CHIU
GWGuan-Chi Wang
Guan-Chi Wang
YCYu-Chen Chang
Yu-Chen Chang
For the low voltage, high current, isolated DC-DC converter applications, current-fed type converter has the chance to achieve higher efficiency due to the lower transformer root mean square current compared with other well-known converters such as dual active bridge or LLC. A current-fed phase-shifted full-bridge, CFPSFB converter has the advantages of nearly full range zero-voltage-switching and soft-commutating without large size of passive or active snubber circuit because the phase-shift of secondary full-bridge is controlled to be proportional to the input current. However, as a front-end stage of a single phase inverter, the input secondary harmonic current (SHC) propagating from the output AC load may cause large voltage spike to damage the primary MOSFETs due to losing the soft-commutating property. SHC may also reduce the conversion efficiency and the lifespan of battery intensely. This paper proposes a simple control scheme based on virtual series impedance method with a notch filter in control loop to reduce the SHC and maintain good dynamic performance. A small-signal model of CFPSFB for a reliable controller design is derived and verified by simulation. A 48 V/3 kW maximum output power inverter prototype is built to verify the theoretical analysis. The maximum efficiency of the DC-DC stage is 97.4% and the peak to peak SHC is less than 10% of the average input current.

1 October 2017
Verified
Conference Paper
Closed access
YLYu-Chen Liu
Yu-Chen Liu
KKKatherine A. Kim
Katherine A. Kim
KCKai-De Chen
Kai-De Chen
YCYu-Chen Chang
Yu-Chen Chang
BHBing-Siang Huang
Bing-Siang Huang
HUANG-JEN CHIUHUANG-JEN CHIU
HUANG-JEN CHIU
A three-phase interleaved boost converter stage of an ac-dc PFC converter that uses GaN switches is developed that utilizes a feed-forward band-stop filter control method to suppress low-frequency output voltage ripple. To increase power density, the converter switches at 500 kHz, operates in triangular current mode (TCM) to achieve zero voltage switching (ZVS), and uses GaN switching devices. A 1-kW laboratory prototype was designed and tested to verify feasibility. With the proposed controller, output ripple was reduced by 70%. Overall efficiency is greater than 96.5% and power density is 65.028 W/in 3 .

1 January 2014
Verified
Book Chapter
Closed access
PDF file
NWNai Jian Wang
Nai Jian Wang
YCYen Chieh Chang
Yen Chieh Chang
YKYin Hao Kuo
Yin Hao Kuo