31 October 2008 in Science
Fundamental to our understanding of erosional and transport phenomena in earth-surface dynamics and engineering is knowledge of the conditions under which sediment motion will begin when subjected to turbulent flow. The onset criterion currently in use emphasizes the time-averaged boundary shear stress and therefore is incapable of accounting for the fluctuating forces encountered in turbulent flows. We have validated through laboratory experiments and analytical formulation of the problem a criterion based upon the impulse imparted to a sediment grain. We demonstrate that in addition to the magnitude of the instantaneous turbulent forces applied on a sediment grain, the duration of these turbulent forces is also important in determining the sediment grain's threshold of motion, and that their product, or impulse, is better suited for specifying such conditions.
1 December 2010 in Journal of Hydraulic Engineering
This paper presents results of several large-eddy simulations (LES) of turbulent flow in an open channel through staggered arrays of rigid, emergent cylinders, which can be regarded as idealized vegetation. In this study, two cylinder Reynolds numbers, and , and three vegetation densities are considered. The LES of the lowest density and at corresponds to a recently completed laboratory experiment, the data of which is used to validate the simulations. Fairly good agreement between calculated and measured first- and second-order statistics along measurement profiles is found, confirming the accuracy of the simulations. The high resolution of the simulations enables an explicit calculation of drag forces, decomposed into pressure and friction drag, that are exerted on the cylinders. The effect of the cylinder Reynolds number and the cylinder density on the drag and hence on the flow resistance is quantified and in agreement with previous experimental studies. Turbulence structures are visualized through instantaneous pressure fluctuations, isosurfaces of the Q-criterion and contours of vertical vorticity in horizontal planes. Analysis of velocity time signals and distributions of drag and lift forces over time reveals that flow and turbulence are more influenced by the vegetation density than by the cylinder Reynolds number.
19 December 2008 in Journal of Geophysical Research: Earth Surface
Better understanding of the role of vegetation in the transport of fluid and pollutants requires improved knowledge of the detailed flow structure within the vegetation. Instead of spatial averaging, this study uses discrete measurements at multiple locations within the canopy to develop velocity and turbulence intensity profiles and observe the changes in the flow characteristics as water travels through a vegetation array simulated by rigid dowels. Velocity data was collected with a one dimensional laser Doppler velocimeter under emergent and submerged flow conditions. The effects of dowel arrangement, density, and roughness were also examined. The results show that the velocity within the vegetation array is constant with depth and the velocity profile is logarithmic above it, however the boundaries are marked by inflection points. The strongest vortices and turbulence intensities can be found there, especially in the region immediately downstream of a dowel. These results support the idea that the flow in the region near the bed and at the top of the dowel array is very unstable leading to the formation of coherent structures and are areas of significant mass and momentum exchange.
14 April 2010 in Journal of Geophysical Research: Earth Surface
1 September 2012 in Journal of Hydraulic Engineering
Vegetation as multiple stems in various configurations or an isolated stem profoundly alters turbulent flows. Past research has shown that these alterations influence sediment transport and stream morphology, but entail complex interactions and feedbacks between flow, vegetation, and sediment processes that involve many parameters. These interactions are examined here for a variety of macrophyte patterns and scales in riverine environments. Flow Reynolds number, canopy density, and submergence ratio are just a few of the key parameters that influence the spatial variability of the flow, momentum transfer, vortex shedding and dissipation, and instantaneous stresses that are known to affect sediment and morphological processes in rivers. Knowledge gaps, though, still remain. A taxonomy that classifies vegetated flows as dense, sparse, or isolated on the basis of threshold parameters like the ratio of stem diameter to stem spacing would be useful for comparing studies among researchers and predicting...
1 December 2010 in Journal of Hydraulic Engineering
The use of in-stream flow training structures for channel stabilization has become increasingly popular due to its potential cost effectiveness and ecological benefits. When properly designed and maintained, these structures help to protect the channel from erosion and lateral migration and may also provide grade control. Additionally, in-stream structures may improve fish and macroinvertebrate habitat and increase hyporheic exchange. However, a large number of these projects fail due to inadequate design guidelines. In this study, various types of in-stream sill and deflector structures are described. A literature review including case studies, journal articles, and standards developed by various agencies suggests design guidelines which are currently available but do not meet the rigorous engineering-based hydraulic design criteria necessary for success. A practitioner opinion survey of personnel from state agencies, federal agencies, and private firms indicates that these structures are being used exte...