18 August 1997 in Applied Physics Letters
Heteroepitaxial Y2O3 films were grown on Si(100) substrates by the technique of reactive ionized cluster beam deposition. The crystallinity of the films was investigated with reflection high energy electron diffraction (RHEED), glancing angle x-ray diffraction (GXRD), and the interface was examined by high resolution transmission electron microscopy (HRTEM). Under the condition of 5 kV acceleration voltage at the substrate temperature of 800 °C, the Y2O3 film grows epitaxially on the Si(100) substrate. RHEED and GXRD results revealed that the epitaxial relationship between Y2O3 and Si(100) is Y2O3(110)//Si(100), and HRTEM observation showed a sharp interface without an amorphous layer.
15 May 2006 in Applied Physics Letters
The characteristics of nitrided films suggest that the diffusion of Si from the Si substrate to the film surface is induced by annealing in an ambient and that the incorporation of N is closely related to the diffusion of Si. Changes in the core-level energy state of the N peaks of nitrided films indicate that the quantity of N incorporated into the film drastically increases with increasing annealing temperature, especially at temperatures over . The incorporated N is mostly bonded to Si that diffused from the Si substrate into the film, while some N is incorporated to at high annealing temperature. Some molecular is generated in the film, which is easily diffused out after additional annealing. Moreover, the chemisorbed N in the film is not completely stable, compared to that at the interfacial region: i.e., the N in the film predominantly out diffuses from the film after additional annealing in a ambient.
1 September 2005 in Physical Review B
Medium energy ion scattering (MEIS) has been used to measure at the scale of the monolayer the deformation profile of self-organized GaN quantum dots grown on AlN by molecular-beam epitaxy. The effect of capping the GaN dots by a thin layer of AlN has also been studied. It is shown that GaN dots are partially relaxed in every situation. Capping them with AlN has little effect on the basal plane, as expected, but strongly modifies the strain of the upper part of dots. The experimental results are compared with theoretical calculations, allowing one to conclude that GaN quantum dots experience a nonbiaxial strain, which drastically decreases when going from the basal plane up to the apex of the dots.
8 December 2005 in Applied Physics Letters
Thermal stability and electronic structure of (HfSiO) ( , 50%, and 75%) grown by atomic layer deposition were investigated by various measurement tools. The quantity of incorporated content changes the binding energy of as the charging effect in the silicate is enhanced with the quantity . When the annealing temperature is increased over 800 °C, phase separation between and is observed in the films with 50% and 75% , while it does not occur in a Hf-silicate film with a high mole fraction of . The phase separation begins in the surface region via the segregation of . After the annealing treatment, the quantity of supplied to the film surface due to interfacial interactions influences the phase separation process, resulting in no phase separation being observed, even at a high annealing treatment of 900 °C.
22 May 2006 in Journal of Vacuum Science & Technology A
Changes in the structural and electrical properties of a alloy thin film induced by phase transition were investigated using various analytical techniques. X-ray diffraction and scanning photoelectron microscopy showed that the phase separation occurred in a local area of the film during a phase transition when the amorphous structure was being transformed into crystalline structures. It was found that the heterogeneous distribution of Sb atoms that diffused during the phase transition accompanied the phase separation. Atomic force microscopy was used to examine the changes in surface morphology and roughness. The electrical conductance of the film was dramatically improved after the phase transition from an amorphous structure to crystalline structures as evidenced by the sheet resistance measurements. The sheet resistance changed from during the phase transition. Differential scanning calorimetry was used to determine the exact phase transition temperature and the effective activation energy for the phase transition on the basis of Kissinger’s equation.
1 April 2004 in Surface Science