7 January 2022 in IEEE Access
Multiphase inverters (MPIs) continue to increase in popularity owing to their compelling features that include enhanced fault-tolerance capability, improved per-phase power handling, and reduced dc-bus capacitor sizing. This article presents a comprehensive review on MPIs and their application in transportation electrification. More specifically, voltage source inverter (VSI) and nine-switch inverter (NSI) are the two MPI topologies reviewed herein, due to their popularity and potential for employment as traction inverters. The state-of-the-art review covers modeling and control techniques, dc-capacitor sizing, modulation strategies, inverter losses, and cost. Promising future trends of MPIs in terms of topologies, switching devices and integrated design are also investigated.
1 March 2018 in International Journal of Electrical Power & Energy Systems
12 October 2022 in IEEE Transactions on Power Electronics
Multiphase drives (MPD) in general and six-phase in particular have been gaining popularity in many industries, which calls for a proper multiphase inverter (MPI) design. For voltage source inverter (VSI)-fed drives, the knowledge of voltage and current stresses on the dc-link are imperative for input capacitor sizing. To this end, the voltage and current stresses on the dc-link capacitor in two-level six-phase VSIs are examined thoroughly in this article for two configurations of load/winding spatial distribution: symmetric and asymmetric. First, the harmonic spectrum of the input dc current of each inverter is analyzed in detail by benchmarking them against the conventional three-phase VSI, to precisely establish the dc-capacitor requirement reduction in six-phase counterparts. Second, analytical formulae for the dc-link capacitor voltage ripples are derived for both configurations. Third, simple formulae for dc-capacitor sizing for six-phase VSIs with different load configurations are provided. The accuracy of the derived formulae is verified by simulation and experimental testing at various power factors and modulation depth. It is found that six-phase VSI supplying symmetric and asymmetric loads reaps 10% and 7% lower dc-link current ripples, respectively. Hence, six-phase symmetric loads yield the smallest capacitor size.
8 September 2023 in IEEE Transactions on Transportation Electrification
Six-phase drives are gaining popularity in electric vehicle (EV) applications owing to their superior fault-tolerance capability, modularity, and improved current handling. However, a thorough design of a six-phase traction inverter has not been investigated. As a result, inherent advantages of six-phase inverters are not exploited. This paper presents a holistic design methodology for a six-phase traction inverter. At the power device level, discrete Silicon Carbide (SiC) MOSFETs are utilized, and their electrothermal model is used to effectively size a liquid-cooled heat sink. At the DC-capacitor level, a multi-objective optimization algorithm is proposed to find the most suitable capacitor bank in terms of volume, impedance, and current capability. At the system level, coreless hall-effect current sensor integrated circuits (ICs) are proposed to mitigate the higher count of sensors in six-phase systems. At the mechanical design level, design constraints are considered to deliver a housing with an integrated coolant channel. The resultant inverter design is prototyped and experimentally tested. The proposed design demonstrates a 7% reduction in DC-capacitor volume and 21% reduction in cabling cost when compared to conventional three-phase inverters of the same volt-ampere rating. The peak power density of the prototype inverter is 70 kW/L, demonstrating a compact design.