25 June 2020 in IEEE Transactions on Transportation Electrification
The next generation of steering system in auto manufacturing industry would be steer-by-wire (SBW) in which mechanical connection between vehicle steering wheel and tires is removed. Numerous advantages are envisaged for this modification but there are still some under-research technical and safety-related challenges to be addressed. This paper presents a thorough review on the history of vehicle steering systems first. The structure and components of the cutting edge technology SBW system are subsequently described with the advantages and disadvantages discussed in detail. The main challenges of this system including the required motor-drives equipped with advanced controllers and reliability concerns are studied and proposed solutions presented in literate are reviewed. Finally, a projection of the future of steering systems considering driverless vehicles with integrated steering and traction systems is briefly presented.
1 March 2021 in Electrical Engineering
23 November 2023 in e-Prime - Advances in Electrical Engineering, Electronics and Energy
17 September 2025 in IEEE Access
Alternate arm converters (AAC) are emerging as one of the most efficient voltage source converter (VSC) topologies in high-voltage direct current (HVDC) systems due to their advantages over conventional modular multilevel converters (MMCs). Compared to conventional MMC, they benefit from fewer number of submodules (SMs), lower capacitance per submodule and DC fault ride-through capability. However, the AAC VSC controller must ensure appropriate regulation of AC currents in both overlap and non-overlap modes while maintaining minimal harmonic distortion. This paper presents an optimized control design method for the half-bridge (HB) AAC VSC using a Fuzzy Logic (FL) controller. The average modeling of multilevel converters is used to reduce computational burden, and the proposed FLC scheme is employed to regulate AC and circulating currents. The performance of the proposed control architecture is evaluated under short and extended overlap operating modes. Sensitivity analysis of the proposed controller against changes in VSC design parameter of overlap period is also investigated to examine the proposed scheme usefulness in different operating conditions. A two-terminal HVDC link using AAC VSC converters is modeled in MATLAB/Simulink and simulation results under different operating conditions are presented to demonstrate the effectiveness of the proposed scheme.
1 January 2026 in IEEE Access
SGSayyed Mohammadtaghi Mousavi Ghahfarokhi
Sayyed Mohammadtaghi Mousavi Ghahfarokhi
The rapid growth of renewable energy harvesting and the integration of renewable energy systems into power systems have significantly increased electricity market attention towards utilizing Direct Current (DC) power systems. The protection of DC systems is still recognized as a challenge to their widespread deployment. Fast DC Circuit Breakers (CBs) are critical components required to ensure the safe and reliable operation of DC systems. Compared to Insulated-Gate Bipolar Transistor (IGBT)-based solid-state DC CBs presented so far, thyristor-based CBs benefit from reduced conduction losses and lower development costs. Nevertheless, this technology has drawn less attention due to the difficulty in the main DC CB valve commutation in the event of a DC fault. This paper presents a new topology for a unidirectional thyristor-based DC CB for low- and medium-voltage DC systems, addressing the above-mentioned challenges by incorporating a series capacitor block. Compared to the existing topologies presented in the literature, the proposed topology offers several key advantages, including fast operation response, high reliability, reduced main and auxiliary DC CB valves voltage stress, and reduced manufacturing cost. Detailed principle of operation is presented, and simulation results are provided using DC CB modeling in PSCAD/EMTDC software. In addition, a prototype 310 V DC CB with a nominal current of 3.1 A is designed, built, and tested as a scaled-down experimental testbed to verify the effectiveness of the proposed topology.