22 July 2024 in IEEE Transactions on Antennas and Propagation
A novel reconfigurable metasurface reflector with a simple architecture is proposed based on either PIN or varactor diodes for magnitude and phase control, respectively. Each metasurface reflector is based on a single-dielectric two-metal-layer printed-circuit board (PCB), with a tunable resonator on the top metal layer and biasing on the bottom metal layer. The metasurface reflectors are designed for reconfigurability on a column-by-column basis (i.e., single-plane beamforming). Biasing is integrated in the design of the unit cell and RF-DC isolation is implemented at the ends of each reflector column. The bias lines are designed to have minimal effect on the resonator characteristics, while appropriate architectures are devised for each configuration involving PIN or varactor diodes. To demonstrate various functionalities of the metasurfaces, the PIN-based metasurface reflector is used to demonstrate magnitude control, side-lobe level control, and binary amplitude grating to generate three symmetrical beams. The varactor-based metasurface reflector is used to demonstrate single beam-steering and binary phase grating to generate two symmetrical beams.
2 August 2024 in IEEE Transactions on Antennas and Propagation
A simple waveguide-Floquet mapping is proposed and theoretically investigated that links the scattering response of a sub-wavelength metasurface unit cell under an infinite periodic array configuration and when measured inside a shielded rectangular waveguide environment. This mapping is based on extracting the effective surface susceptibilities as the fundamental constitutive parameters of the cells, via the Generalized Sheet Transition Conditions (GSTCs) of the unit cell using the waveguide measurements, and then reconstructing the unit cell response at an arbitrary incidence angles. Using two examples of a transmissive Huygens’ metasurface and a purely reflective metasurface, the proposed waveguide-Floquet mapping is numerically confirmed to determine the complete angular scattering of the unit cells. The proposed waveguide-Floquet mapping thus represents a simple technique to experimentally determine the angular scattering characteristics of the unit cell using a low-cost effective waveguide measurements.
22 February 2024 in IEEE Journal of Radio Frequency Identification
The deleterious effect of eddy current due to the presence of a metal in magnetically coupled resonant high-frequency radio frequency identification (HF RFID) systems is addressed, and remediation using a resonant loop is discussed. The proposed solution is much more economic than conventional ferrite-based shielding. The resonant loop, which is referred to as auxiliary coil in this paper, does not increase the profile of the existing HF RFID tag. Analysis is carried out using full-wave numerical simulation resulting in an equivalent circuit model, and validated with measurements. The technique is illustrated through applications like HF RFID tags in close proximity to a metal seal required for induction sealing, as well for extending read range of readers compelled to operate near metallic environment.