30 December 2024 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
This paper reports a surface acoustic wave (SAW) resonator at 52 GHz with a high quality factor ( Q ) of 188 and a high phase velocity of 12.2 km/s, marking the first millimeter wave (mmWave) SAW devices with high Q . Transferred 300 nm 128Y lithium niobate (LN) thin film on 4H silicon carbide (SiC) substrate is used for the acoustic platform. The dramatic frequency scaling is enabled by the high phase velocity thickness-shear mode, confined in the LN-SiC stack, thanks to the high stiffness and acoustic velocity of SiC. The high phase velocity of 12.2 km/s is approaching the longitudinal wave velocity of 12.5 km/s in 4H SiC. The resonator achieves electromechanical coupling ( k 2 ) of 0.5%, 3-dB series resonance Q ( Qs ) of 12, 3-dB shunt resonance Q ( Qp ) of 188, and maximum Bode Q of 154. Upon further development, the mmWave solidly mounted acoustic platform could enable various applications in signal processing, optomechanical, and quantum applications.
5 January 2026 in IEEE Transactions on Ultrasonics
The need for high-temperature piezoelectric microelectromechanical systems (MEMS) requires pushing piezoelectric platforms to their thermal limits. In harsh thermal environments, piezoelectric MEMS devices are expected to sustain severe damage because of material degradation and coefficient of thermal expansion (CTE) mismatches between the functional layers and the carrier wafer. This paper investigates the thermal endurance of the suspended thin-film lithium niobate (LN) platform by observing the structural integrity and performance of acoustic Lamb wave resonators after annealing rounds at increasing temperatures, with a focus on temperatures between 550 °C and 800 °C, with 50 °C temperature increments. Fundamental symmetric (S0) mode acoustic resonators are fabricated on 600 nm stoichiometric LN (sLN) with 40 nm thick platinum top electrodes and a thin titanium adhesion layer. After each annealing round, changes in the devices’ resonant frequency and quality factor (Q) are quantitatively studied. The devices and material stack are further analyzed with resistivity structures, optical microscope images, and X-ray diffraction (XRD) measurements. The results provide valuable insights into the design and material selection necessary to optimize the suspended thin-film LN platform for high temperatures. Understanding the thermal limit of the platform enables its use for sensors, actuators, resonators, and potentially other thin-film LN microsystems, e.g, photonics, electro-optical, and acousto-optical systems in harsh thermal environments.