The purpose of this research is to analyze the emission, combustion, and performance parameters of a CRDI diesel engine fueled by waste cooking oil (WCO) biodiesel (B20%), diesel (80%), and their blend with two distinct metal-based nanoparticles cerium oxide (CeO2) and aluminum oxide (Al2O3). Transesterification was used to produce biodiesel from waste cooking oil (WCO). An ultrasonication procedure was used to gradually mingle the nanoparticles with a B20-diesel fuel blend in mass fractions of 50 and 100 ppm. The developed nanoparticle fuel samples were designated as (B20 + 50 Al2O3, B20 + 100 Al2O3, B20 + 50 CeO2, B20 + 100 CeO2). The CRDI engine was run at a constant speed with four different engine loads: 3 kg, 6 kg, 9 kg, and 12 kg. The result showed that the presence of Al2O3 in the blended fuel improved the BTE by 11.39%, reduced the SFC by 13.74%, and increased the cylinder pressure and heat release rate (HRR) by 16.77% and 21.48% respectively compared to B20 fuel at peak load condition. Regarding harmful emissions, CO emissions decreased by 15.06% for B20 + 50 Al2O3 than B20 and HC emissions decreased by 50% for B20 + 50 CeO2 than diesel at peak load. Further, NOx is reduced by 18.29% for B20 + 50 CeO2 than B20 at peak loads. Graphical Abstract
20 April 2023 in Environmental Progress & Sustainable Energy
In the experimental study, biofuel is extracted from two distinct waste cooking oil of palm and sunflower oil through a transesterification process. A suitable blend B20 (WCPME 10% + WCSME 10% + Diesel 80%) is prepared by mixing diesel in biofuel. After that, using an ultrasonicator, Al2O3 was mixed in B20 at the distinct proportions of 25, 50, and 100 ppm, respectively, and new ternary blends are developed: B20 + 25Al2O3, B20 + 50Al2O3, and B20 + 100Al2O3. The experiment test was performed on a CRDI engine fuelled by Diesel, B20, B20 + 25Al2O3, B20+50Al2O3, and B20 +100Al2O3 samples at a steady speed of 1500 rpm and different engine loads to evaluate engine performance, combustion, and emission characteristics. The test result depicts that BTE extensively improved by 13.53% and SFC reduced by 20.93% for B20 +100 Al2O3 than B20 at full load. The emission characteristics, for example, CO, and HC were altogether decreased with the mixing of nanoparticles in the correlation of B20 and D100 yet there is a slight increment in NOx emissions than B20 and D100. Higher peak points in CPmax and HRRmax reached for B20 +100Al2O3 because of reduced ignition delay than that of B20 and D100.
12 December 2025 in Environmental Progress & Sustainable Energy