The literature about direct solid sampling (SS) and slurry sampling atomic absorption spectrometry (AAS) over the past decade has been surveyed critically. It became apparent that a very significant change had occurred, particularly in the relation between the two major techniques used for that purpose. In the 1990s, slurry sampling was typically considered the technique of choice, combining the significant advantages of the solid and the liquid sampling methods, at least in part because of the availability of a commercial accessory for automatic slurry sampling. The situation is completely inverted now, as the above accessory has been discontinued and rugged and reliable accessories for direct SS became available. Direct SS electrothermal (ET) AAS has been shown to provide the best limits of detection because of the absence of any dilution and a minimal risk of contamination. Calibration against aqueous standards appears to be feasible after careful program optimization. The absence of any significant sample handling makes SS ET AAS ideally suited for fast screening analyses. The introduction of high‐resolution continuum source AAS appears to open additional attractive features for SS ET AAS because of the significantly simplified optimization of furnace programs and the visibility of the spectral environment, which makes it easy to avoid spectral interferences. New calibration strategies make a “dilution” of samples unnecessary, which used to be one of the major limitations of SS ET AAS. Finally, direct SS analysis is an important contribution to clean chemistry, as practically no reagents are used.
31 August 2006 in Spectrochimica Acta Part B: Atomic Spectroscopy
A method has been developed for the determination of antimony in airborne particulate matter collected on glass fiber filters using direct solid sampling and high-resolution continuum source graphite furnace atomic absorption spectrometry. The certified reference material, BCR 176 (City Waste Incineration Ash) has been analyzed for validation purposes; no statistically significant difference has been found between the certified and the determined value for antimony based on a Student t-test at a 95% confidence level. The secondary antimony absorption line at 212.739 nm, which is about a factor of 20 less sensitive than the primary resonance line, has been used in order to adapt the sensitivity of the method to the antimony concentration in the samples. 400 μg of ruthenium, thermally deposited on the solid sampling platform has been used as permanent modifier. The characteristic mass at this line was found to be m0 = 0.7 ng Sb. The limit of detection (3σ), based on ten atomizations of an unused filter was found to be 15 μg g−1, corresponding to 40 ng m−3 for a typical air volume of 1440 m3. The limits of quantification, based on the same measurements were 50 μg g−1 and 128 ng m−3, respectively. The repeatability of the measurements has been between 4% and 9% (n = 5). The antimony concentration found in filter samples varied between <15 μg g−1and 342 ± 16 μg g−1, corresponding to <40 ng m−3 and 1820 ± 90 ng m−3, respectively. Direct solid sample analysis and detection by high-resolution continuum source graphite furnace atomic absorption spectrometry proved to be a simple, fast and reliable alternative for the determination of Sb in airborne particulate matter. An attempt to transfer the method to conventional line source equipment has been without success because of spectral interference and the weak emission of the secondary line from a hollow cathode lamp.