1 January 2007 in Journal of Applied Physics
Ultrathin crystals of the layered transition-metal dichalcogenide (semiconducting) and (metallic) were obtained by mechanical peeling or chemical exfoliation techniques and electrically contacted using electron-beam lithography. The devices showed high field-effect mobility in the tens of and an on/off ratio higher than . The devices remained metallic despite the fabrication process and showed an enhancement of the superconducting transition temperature and disappearance of the charge density wave phase anomaly at low temperature.
17 September 2008 in Physical Review B
We compare the main feature of the measured Raman-scattering spectra from single layer graphene with a bilayer in which the two layers are arbitrarily misoriented. The profiles of the two-dimensional (2D) bands are very similar in having only one component, contrary to the four found for commensurate Bernal bilayers. These results agree with recent theoretical calculations and point to the similarity of the electronic structures of single layer graphene and misoriented bilayer graphene. We also show that the dependence of the 2D frequency on the laser excitation energy is different in these two latter systems.
27 September 2013 in Nature Communications
The optical properties of single-wall carbon nanotubes are very promising for developing novel opto-electronic components and sensors with applications in many fields. Despite numerous studies performed using photoluminescence or Raman and Rayleigh scattering, knowledge of their optical response is still partial. Here we determine using spatial modulation spectroscopy, over a broad optical spectral range, the spectrum and amplitude of the absorption cross-section of individual semiconducting single-wall carbon nanotubes. These quantitative measurements permit determination of the oscillator strength of the different excitonic resonances and their dependencies on the excitonic transition and type of semiconducting nanotube. A non-resonant background is also identified and its cross-section comparable to the ideal graphene optical absorbance. Furthermore, investigation of the same single-wall nanotube either free standing or lying on a substrate shows large broadening of the excitonic resonances with increase of oscillator strength, as well as stark weakening of polarization-dependent antenna effects, due to nanotube–substrate interaction.
4 July 2007 in Nano Letters
30 April 2008 in Physical Review B
We present here comparative measurements by scanning electron microscopy (SEM) and field emission (FE) of the mechanical resonances of singly clamped, batch-fabricated SiC nanowires as well as an extensive theoretical description. The mechanical resonances of six nanowires, which were glued to the ends of tungsten support tips, were electrostatically excited and detected visually in the SEM configuration and then by FE microscopy image processing. The large tensions generated by electric field pulling in FE that tune the resonance frequencies and the complex boundary conditions at both the free and clamped nanowire ends complicate the interpretation of the resonance frequencies necessary for extracting intrinsic mechanical parameters. Our model fully takes into account these effects and results in an excellent agreement with the measured resonance modes in both configurations. Analytical solutions with their validity conditions are given for the low and high tension ranges and semianalytical solutions for the intermediary range. Viable estimates of Young’s modulus are thus achieved for the ultra high vacuum (UHV) environment of FE. Progressive in situ cleaning was performed in the FE-UHV configuration in the range of , which increased the factor of the first mechanical resonance by up to and did not alter the value of the Young’s modulus measured previously in the SEM configuration. The agreement between the SEM and FE techniques means that we can now profit from their different strengths for better understanding the mechanics of nanowires and nanotubes.