1 July 2018 in Gait & Posture
Chronic ankle instability (CAI) has previously been linked to altered lower limb kinematics and muscle activation characteristics during walking, though little research has been performed analysing the full time-series across the stance and swing phases of gait. The aim of this study was to compare trunk and lower limb kinematics and muscle activity between those with chronic ankle instability and healthy controls. Kinematics and muscle activity were measured in 18 (14 males, 4 females) healthy controls (age 22.4 ± 3.6 years, height 177.8 ± 7.6 cm, mass 70.4 ± 11.9 kg, UK shoe size 8.4 ± 1.6), and 18 (13 males, 5 females) participants with chronic ankle instability (age 22.0 ± 2.7 years, height 176.8 ± 7.9 cm, mass 74.1 ± 9.6 kg, UK shoe size 8.1 ± 1.9) during barefoot walking trials, using a combined Helen Hayes and Oxford foot model. Surface electromyography (sEMG) was recorded for the tibialis anterior and gluteus medius. Full curve statistical parametric mapping was performed using independent and paired-samples T-tests. No significant differences were observed in kinematic or sEMG variables between or within groups for the duration of the swing phase of gait. A significantly increased forefoot-tibia inversion was seen in the CAI affected limb when compared to the CAI unaffected limb at 4-16% stance (p = 0.039). No other significant differences were observed. There appears to be no differences in muscle activation and movement between CAI and healthy control groups. However, participants with CAI exhibited increased inversion patterns during the stance phase of gait in their affected limb compared to their unaffected limb. This may predispose those with CAI to episodes of giving way and further ankle sprains.
2 April 2013 in International Journal of Sports Medicine
The aim of this study was to investigate the reliability of fatigue indicators calculated from peak torque and total work during isokinetic speeds of 60, 90, 120 and 180° · s−1 during a hip fatigue protocol. 10 males suffering from a history of unilateral functional ankle instability and 10 male healthy controls performed 5 maximal concentric contractions on an isokinetic dynamometer. Following a 4 min rest period subjects were instructed to perform repeated maximal concentric contractions to fatigue, which was defined as 3 consecutive repetitions below 50% of the maximum peak torque value. Each testing speed was randomised with 24 h between speeds. The subjects were asked to return to the laboratory 7 days later to repeat the 4 speeds, with 24 h between speeds. Muscle fatigue was determined for each testing speed by the fatigue index, the percent decrease in performance and the slope of the regression equation. The most reliable fatigue determination method was the slope of the regression equation, when testing at a speed of 120° · s−1. It is recommended that future investigators examine and plot their data before choosing the slope of the regression equation as their fatigue indicator, as a linear model is required.
26 February 2013 in International Journal of Sports Medicine
The purpose of this study was to quantify the components of acceleration, load range and deceleration through a velocity spectrum during concentric hip abduction and adduction isokinetic exercise, and to investigate the effect of load range on peak torque and work done. 16 male healthy subjects performed 3 maximal concentric reciprocal hip abduction and adduction gravity corrected repetitions in a fixed order at 60, 120, 180, 240, 300, 360 and 420° · s−1, with a 30 s rest between velocities. Hip abduction and adduction results revealed that load range significantly decreased while acceleration and deceleration ROM significantly increased (p<0.05) with each increase in velocity. When the total peak torque data was corrected for load range there was a significant decrease (p<0.05) in peak torque at velocities of 300° · s−1 and above, for both hip abduction and adduction. Load range correction also resulted in a significant decrease (p<0.05) in work done at velocities of 120° · s−1 and above, for both hip abduction and adduction. The results demonstrate an inverse relationship between isokinetic velocity and load range during concentric hip abduction and adduction, and suggest a need for the clinician to carefully consider velocity selection when performing exercise on an isokinetic device.