27 December 2022 in IEEE Journal of Photovoltaics
Triple cation mixed halide perovskite solar cells have exhibited a great deal of interest and could be the potential candidate with an enhanced power conversion efficiency (PCE) as compared to conventional perovskite solar cells. In this article, we have simulated the various photovoltaic characteristics of [Cs 0.05 (MA 0.17 FA 0.83 ) 0.95 Pb(I 0.83 Br 0.17 ) 3 ] based mixed cation mixed halide perovskite solar cells in n-i-p configurations. We have demonstrated and substantiated the experimentally reported device performances in identical device configurations using the same materials. The effect of variation in different hole transport layers, electron transport layers, doping density, and the thickness of various layers on device performance is thoroughly analyzed through our simulation. Further optimization of device performance is carried out by changing the thickness, doping concentration, and defect density of the active layer, and the PCE of 25.95% is achieved.
22 August 2025 in Progress in Materials Science
12 February 2025 in Sustainable Energy & Fuels
Flexible perovskite solar cells (F-PSCs) are highly promising for harvesting solar energy in various environments, both indoors and outdoors. Nonetheless, one of the main hurdles to the widespread commercial use of F-PSCs is the thermal evaporation of the metal top electrode, a time-consuming process that substantially increases the cost related to both raw materials and fabrication equipment. Consequently, developing effective alternatives is essential for harnessing the full potential of this technology. One promising approach is to replace the top metal electrode with carbon-based materials, which can effectively serve as both the hole transport layer (HTL) and back electrode. These materials are low cost and compatible with inexpensive, simple, and scalable deposition techniques, such as blade coating. However, HTL-free carbon-based PSCs (C-PSCs) currently suffer from power conversion efficiency (PCE) lower than their metal counterparts, due to inefficient charge transfer and collection, associated with an ineffective perovskite (PVK) and carbon electrode interface. By utilizing a suitable HTL between the PVK and the carbon electrode, the charge extraction can be effectively improved and the interfacial recombination reduced. Throughout this work, a screening of suitable hole transport materials (HTMs) was carried out to select the most promising candidate to improve the performance of C-PSCs on flexible substrates. Copper(I) thiocyanate (CuSCN) was employed as the HTL with a wide band gap (3.5–3.8 eV). At the optimized concentration of 10 mg ml−1, a PCE of 9.4% was achieved on 1 cm2 flexible devices. The results obtained were compared with the performance of F-PSCs with gold top electrodes using organic PTAA as the HTL as state-of-the-art reference. The optimization of the HTL allowed for the demonstration of a significant improvement in the performance of the device, which could pave the way for the large-scale commercialization of PSCs with low environmental impact and promising cost-effectiveness.
18 August 2026 in Nature Energy
Indoor photovoltaics harvests energy from light available inside homes and buildings for powering the Internet of Things, wireless sensors and consumer and medical electronics. A major challenge in this field is a lack of standardized testing conditions. Here a team from more than 60 research institutions and companies proposes best practices for evaluating indoor photovoltaic performance and establishing baseline stability tests. We base these recommendations on recent experimental data, published literature, practices used in academic and industrial settings, technical specifications from standards organizations, lighting databases and existing regulations. We outline procedures that begin with the recommendation of a single artificial light source, followed by guidance on setting up measurement systems and a step-by-step guide for conducting measurements and tests. These procedures are consolidated into three checklists. Our aim is to promote accurate measurement of laboratory and commercial solar cells and modules under indoor lighting, facilitating comparability across academia and industry worldwide.
1 January 2026 in EES Solar
Fully blade-coated, HTL-free carbon-based perovskite solar cells processed under ambient conditions deliver 29.34% indoor PCE, with the same architecture extended to a 10.40 cm² mini module reaching 15.34%.