1 August 2011 in Anesthesiology
Background: The permutation entropy, the approximate entropy, and the index of consciousness are some of the most recently studied electroencephalogram-derived indexes. In this work, a thorough comparison of these indexes was performed using propofol anesthesia in a rabbit model. Methods: Six rabbits were anesthetized with three propofol infusion rates: 70, 100, and 130 mg · kg⁻¹ · h⁻¹, each maintained for 30 min, in a random order for each animal. Data recording was performed in the awake animals 20, 25, and 30 min after each infusion rate was begun in the recovered animals and consisted of electroencephalogram recordings, evaluation of depth of anesthesia according to a clinical scale, and arterial blood samples for plasma propofol determination. Median and spectral edge frequencies were analyzed for single-scale permutation entropy and composite multiscale permutation entropy, approximate entropy, index of consciousness, and the spectral parameters. The spectral parameters and single-scale and multiscale permutation entropies were corrected for the presence of burst suppression. Performance of the indexes was compared by prediction probability and pharmacodynamic analysis. Results: The single-scale and composite multiscale permutation entropies with a burst suppression correction showed better prediction probabilities than did the other electroencephalogram-derived parameters but not better than the electromyographic activity. Conclusion: Single-scale and multiscale permutation entropies may be promising measures of propofol anesthetic depth when corrected for burst suppression. Additional studies should investigate the information measured by electromyography algorithms from commercial monitors of anesthetic depth. The rabbit may be a promising animal model for electroencephalographic studies because it provides a good-quality signal.
15 April 2006 in Journal of Applied Physics
Magnetoresistive biochips have been recently introduced for the detection of biomolecular recognition. In this work, the detection site incorporates a thin-film diode in series with a magnetic tunnel junction (MTJ), leading to a matrix-based biochip that can be easily scaled up to screen large numbers of different target analytes. The fabricated cell matrix integrates hydrogenated amorphous silicon diodes with aluminum oxide barrier MTJ. Each detection site also includes a U-shaped current line for magnetically assisted target concentration at probe sites. The biochip is being integrated in a portable, credit card size electronics control platform. Detection of diameter magnetic nanoparticles by one of the matrix cells is demonstrated.
1 October 2009 in Control Engineering Practice
1 December 2014 in IEEE Control Systems
In biomedical systems, feedback control can be applied whenever adequate sensors, actuators, and sufficiently accurate mathematical models are available. The key issue is the capacity of the control algorithm to tackle the large levels of uncertainty, both structured and unstructured, associated with patient dynamics. In the particular case of intravenous anesthesia considered here, manipulated variables are drug infusion rates, administered by syringe pumps, and the measured signal outputs are the levels of hypnosis or depth of anesthesia (DoA) and of neuromuscular blockade (NMB).
29 June 2011 in International Journal of Systems Science
A solar furnace is a thermodynamic device that concentrates sun radiation in order to achieve high-temperatures at a focus, where a sample of the material to be tested is located. This article address the problem of designing a control architecture for solar furnaces. It is motivated by the use of a solar furnace as an instrument in material science research to perform two types of experimental tests. In the first type, samples are tested in high-temperature stress cycles. In these experiments it is important to control the temperature profile. The second test type is characterised by imposing a solar radiation flux profile. On both experiment types there are strong nonlinear effects, a significant degree of parametric uncertainty and disturbances, such as solar radiation fluctuation due to clouds and to sun's apparent movement. Although the actuator (shutter) is much faster than the thermic system, it may destabilise the overall controlled system. The contribution of this article consists in the design of a control architecture for solar furnaces and the application of singular perturbation methods in order to derive conditions in the form of bounds for the speed of actuator dynamics so that the closed-loop system is stable.
6 February 2024 in Neurocomputing