Now-a-days carbon nanotube (CNT) is widely used because of its inimitable properties such as high electrical and thermal conductivities, high tensile strength, etc. In this work, an attempt has been made to modify the surface of Al-7075 alloy using Cu-MWCNT powder metallurgy green compact tool in the electric discharge machining process. The effects of contributing parameters i.e. peak current (Ip), voltage and compact load (CL) have been investigated with respect to performance measures such as, Material Deposition Rate (MDR), Tool Wear Rate (TWR) and Surface Roughness (Ra). The modified surface has been assessed by optical microscopy, FESEM, XRD and EDS analyses. Highest MDR of 0.15 mg min–1, lowest TWR of 2.05 mg min–1 and lowest Ra of 2.57 µm have been attained. The deposition of tool materials has improved the microhardness up to 2.6 times than that of base material.
The current study investigated the deposition behaviour of the tool particles made from powder metallurgical (PM) green compact tool of W-Cu for coatings on Inconel 800 superalloy substrate using the electric discharge alloying (EDA) process. The effect of process variables such as compact load (CL), voltage (V) and duty factor (DF) is systematically analysed over the output responses, i.e., material deposition rate (MDR), tool wear rate (TWR) and surface roughness (Ra). The results indicated a maximum TWR of 225.325 mg/min, a maximum MDR of 47.250 mg/min and a minimum Ra of 3.5 µm. The alloyed layer is further characterized by FESEM analysis. The weight and atomic percentage of the migrated particles are determined by EDS analysis. The elemental mapping further confirmed the enrichment of tool particles and other base material constituents within the alloyed surface. The XRD analysis further showed the existence of tool elements and the development of new compounds in the alloyed layer. The alloyed layer exhibited an average layer thickness of 11.354 µm.
24 March 2025 in Journal of Materials Engineering and Performance