Omar S. Abdulwahid

Omar S. Abdulwahid

Auto-generated profile, based on publicly available information

Omar S. Abdulwahid

Department of Mechatronics Engineering, College of Engineering University of Mosul Mosul Iraq

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 February 2018 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
SMSaad G. Muttlak
Saad G. Muttlak
OAOmar S. Abdulwahid
Omar S. Abdulwahid
JSJ. Sexton
J. Sexton
MKMichael J. Kelly
Michael J. Kelly
MMMohamed Missous
Mohamed Missous
This work presents an experimental study of InGaAs/AlAs resonant tunneling diodes designed to improve the diode characteristics using five different device structures. A promising high peak to valley current ratio of 5.2 was obtained for a very low current density device. As expected, the measured results show a significant increase in the current density with thinner barriers and quantum well widths. This is, however, at the expense of an increase in the peak voltages for high peak current density devices. A 36mV/μm2 voltage deviation was found for a diode with a peak current density of 10.8 mA/μm2 that we attribute to self-heating of the diodes, which were confirmed using pulsed dc voltage tests. To demonstrate how the self-oscillation at low frequency can be eliminated, a 25Ω resistor was integrated in parallel with the diodes. The experimental findings suggest that the partially stabilizing resistor is limited by the absolute value of the negative differential resistance. The equivalent circuit of the diodes was validated using on-wafer S-parameter measurements up to 40 GHz. An estimated high frequency operation limit of 2.7THz was deduced for RTD sample #327.

1 February 2018 in IET Optoelectronics
Verified
Journal Article
Open access
PDF file
OAOmar S. Abdulwahid
Omar S. Abdulwahid
JSJames Sexton
James Sexton
IKIoannis Kostakis
Ioannis Kostakis
KIKawa Ian
Kawa Ian
MMMohamed Missous
Mohamed Missous
InAlAs/InGaAs avalanche photodiodes (APD) were simulated using physical device models, then designed and fabricated to detect light in the wavelength range from 1.3 to 1.55 µm. DC characterisation under dark and light conditions were performed at room temperature to measure and investigate the performance of the APD. High‐frequency characterisation was carried out on the device to extract the diode intrinsic and extrinsic parameters. The work reported here focuses on the dark and light physical device simulations (both under DC and AC conditions) which were accomplished using Atlas SILVACO tool. The effect of electron velocity overshoot was considered for accurate bandwidth modelling. All measured data are in excellent agreement with the modelled ones. The internal device gain of the APD is 45 at −23.5 V leading to a ∼220 GHz gain–bandwidth product. This successful APD model can be exploited to further improve the diode structure for higher data rate applications beyond 10 Gb/s.

7 December 2017 in IEEE Transactions on Electron Devices
Verified
Journal Article
Open access
KAK. N. Zainul Ariffin
K. N. Zainul Ariffin
YWY. Wang
Y. Wang
MAM. R. R. Abdullah
M. R. R. Abdullah
SMS. G. Muttlak
S. G. Muttlak
OAO. S. Abdulwahid
O. S. Abdulwahid
MMMohamed Missous
Mohamed Missous
A complete description of physical models for fabricated asymmetric spacer tunnel layer (ASPAT) diodes is reported in this paper. A novel In0.53Ga0.47As/AlAs design is presented and compared to the conventional GaAs/AlAs material system. For both material schemes, physical models were developed based on experimental measurements. Simulated dc characteristics of the devices are given for both planar- and back-contacted structures to highlight the impact of spreading resistance on device behavior. Furthermore, full S-parameter derivations from numerical simulation for tunnel diodes are demonstrated for the first time on the basis of quantum-mechanical ac modeling of the capacitance-voltage and conductance-voltage performances of these ASPAT diodes. A negligibly small difference between measured and simulated zero-biased intrinsic capacitances is observed (i.e., ≤ 0.2 fF). These are beneficial for accurate predictive models for device characteristics. In addition, key parameters which can be extracted from simulation results are obtained to aid in the development of millimeter-wave/terahertz applications of these types of heterostructure tunnel devices.

1 June 2019 in IET Optoelectronics
Verified
Journal Article
Open access
PDF file
SMSaad G. Muttlak
Saad G. Muttlak
IKIoannis Kostakis
Ioannis Kostakis
OAOmar S. Abdulwahid
Omar S. Abdulwahid
JSJames Sexton
James Sexton
MMMohamed Missous
Mohamed Missous
A detailed study of the performance analysis of a low‐cost PIN/heterojunction bipolar transistor (HBT) opto‐electronic integated circuit (OEIC) is described. Measured and of 54 and 57 GHz for 10 × 10 µm 2 HBTs were achieved for such a large emitter size. The base and collector regions of the transistor were utilised to form a PIN photodiode which has a dc responsivity and quantum efficiency of 0.5 A/W and 0.45, respectively, without antireflection coating at a wavelength of 1.55 µm. For both active devices, a model was realised taking all parasitic and physical‐based impacts into account, for example, equivalent circuit of the pads surrounding the devices and transit delay time across the collector depletion region. The simulation results of the discrete passive and active elements showed good agreement with experimental measurements. The OEIC module was implemented in Keysight‐advanced design system software with a three‐stage preamplifier which has a transimpedance gain of 40 dB Ω and a −3 dB bandwidth of 18 GHz. This corresponds to a transimpedance‐gain product of 1.8 THz. A series peaking inductor technique was used in the design, contributing to an enhancement in the opto‐electrical bandwidth of >60%. The optical/electrical response offers a bandwidth of ∼15 GHz, adequate for up to 20 Gb/s data rate operation.

21 May 2020 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
ASAbdelmajid Salhi
Abdelmajid Salhi
JSJ. Sexton
J. Sexton
SMS. G. Muttlak
S. G. Muttlak
OAO. Abdulwahid
O. Abdulwahid
AHA. Hadfield
A. Hadfield
MMMohamed Missous
Mohamed Missous
We present work on a novel In0.53Ga0.47As/AlAs metamorphic asymmetric spacer layer tunnel (mASPAT) diode structure, which was grown on GaAs by solid source molecular beam epitaxy. mASPAT diodes with different mesa sizes were fabricated and tested following growth under optimal conditions. The measured I–V characteristics of these tunneling devices showed rectifying behavior resulting from the asymmetric design of the epitaxial spacer layers. The extracted curvature coefficient, junction resistance, and leakage currents at −1 V resulted in an estimated theoretical cut-off frequency f t at zero bias exceeding 180 GHz for 4 × 4 μm2 mesa devices. The obtained results demonstrate the potential use of mASPAT devices on GaAs as a low-cost alternative to devices fabricated on InP substrates for high-volume zero bias microwave and millimeter-wave detectors.

1 February 2019 in IET Optoelectronics
Verified
Journal Article
Open access
PDF file
OAOmar S. Abdulwahid
Omar S. Abdulwahid
IKIoannis Kostakis
Ioannis Kostakis
SMSaad G. Muttlak
Saad G. Muttlak
JSJames Sexton
James Sexton
KIKawa Ian
Kawa Ian
MMMohamed Missous
Mohamed Missous
Validated SILVACO physical models were exploited to optimise electrical and optical characteristics of 1.5 µm wavelength InAlAs–InGaAs Avalanche photodiodes and InGaAs PIN diodes. Optimised SILVACO models were created by selectively thinning down the absorption layers to further reduce the carrier transit time. Further optimisation was accomplished by scaling the light window aperture and mesa area sizes with the aim of reducing the device capacitances. The optimised PIN diode provides a maximum opto‐electric bandwidth of 35 GHz with a current responsivity of 0.4 A/W under −5 V bias voltage and 10 µW incident optical power. At 1 µW incident optical power, the maximum opto‐electric bandwidth and current responsivity of the optimised avalanche diode is 21 GHz and 1.4 A/W under −21.5 V bias voltage. The optimised APD and PIN photo‐detectors are capable of working at a data rate of up to 25 and 40 Gb/s, respectively.