19 May 2025 in IEEE Transactions on Industrial Electronics
This article proposes a natural current balancing method for the interleaved input-parallel output-parallel (IPOP) LLC converter incorporating the partial power processing (PPP) structure. In the proposed configuration, based on the principle of charge balance, the voltage gain of phases can be automatically equalized in the presence of parameter mismatch. This results in the natural balancing of phase currents without sensors or dedicated controls and is independent of the phase-shift angle. Consequently, interleaving operation with 90° phase shift can be employed to reduce output current ripples significantly. Additionally, the PPP structure allows the output voltage of the proposed converter to be regulated with high performance. A 2-kW prototype is built and tested to validate the benefits of the proposedmethod.
9 January 2025 in IEEE Transactions on Industrial Electronics
The multilevel flying capacitor converter (ML-FCC) has garnered widespread recognition and adoption across various applications over decades. However, achieving an efficiency of ≥99% in the three-level (3L) version of this topology presents a significant challenge. To address this barrier and maximize the converter’s efficiency to the greatest extent possible, this article proposes three discontinuous phase-shifted pulse width modulation (DPS-PWM) techniques, which are applied to a 10 kW SiC MOSFET 3L-FCC. These modulation strategies inhibit power device switching when the waveforms reach their peak values, a region referred to as the nonswitching region (NSR) in this article. Even with a substantial load imbalance (>33%), the efficiency of the converter remains largely unaltered. The highest efficiency, achieved at 75% of full load, is approximately 99.55%, while maintaining an efficiency around 99.5% at full load, measured after one hour of fanless operation. Avoiding voltage ripple on flying capacitors (FCs), enhancing the utilization of the input dc voltage/source, and preventing losses associated with FCs and dead-time during the NSR are additional advantages of the proposed modulation approaches.
29 May 2026 in IEEE Transactions on Industrial Electronics
Input-parallel output-parallel (IPOP) LLC converters used in high-power, high-current systems often experience current unbalance due to component tolerances. Active balancing methods require sensors and dedicated controllers, whereas passive methods typically struggle to support interleaved operation. Although partial power processing (PPP) structures offer efficient voltage regulation, applying them to IPOP systems demands multiple auxiliary converters. This article presents a novel interleaved IPOP LLC converter that achieves both PPP functionality and automatic current balancing using only a single auxiliary full-bridge (AFB) stage. A DC-blocking capacitor is inserted to prevent transformer saturation and inherently equalize phase currents, eliminating the need for sensors or controllers. This mechanism enables simultaneous PPP-based voltage regulation, natural current sharing, and 90° interleaving for a significant reduction in output current ripple. The operating principle and characteristics are analyzed, and the concept is validated through simulations and experiments using a 1.8-kW prototype.