Faramarz Faraji

Faramarz Faraji

Auto-generated profile, based on publicly available information

Faramarz Faraji

School of Energy Engineering, Kyungpook National University, Daegu, South Korea

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 July 2020 in IEEE Transactions on Energy Conversion
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
ABAli Akbar Moti Birjandi
Ali Akbar Moti Birjandi
SGSayed Mohammad Mousavi Gazafrudi
Sayed Mohammad Mousavi Gazafrudi
Jianhua ZhangJianhua Zhang
Jianhua Zhang
BWBaocheng Wang
Baocheng Wang
XGXiaoqiang Guo
Xiaoqiang Guo
A single-phase Three-Level Split-Inductor Neutral Point Clamped Inverter-Improved (3L-SI-NPCI 2 ) for transformerless photovoltaic (PV) application is proposed in this article. The proposed inverter utilizes two split inductors, which eliminate the shoot-through issue. Therefore, it is more reliable than conventional converters. Not needing dead time, achieving a high efficiency with lower current THD and low leakage current are other advantages of the proposed inverter. The operation principle, dynamic performance, output filter design and impacts of asymmetric filter inductors on leakage current are illustrated in the 3L-SI-NPCI 2 . The proposed topology is compared to seven existing transformerless topologies by simulation studies and results. Finally, an experimental prototype has been developed to show the benefits of the proposed inverter.

1 April 2022 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
AGAmer M. Y. M. Ghias
Amer M. Y. M. Ghias
XGXiaoqiang Guo
Xiaoqiang Guo
ZCZhaowen Chen
Zhaowen Chen
ZLZhigang Lu
Zhigang Lu
CHChangchun Hua
Changchun Hua
The paper presents a split-inductor flying capacitor (SIFC) converter for medium-voltage applications to improve reliability and eliminate the shoot-through issue. Reliability and lower total harmonic distortion (THD), mainly caused by the pulse width modulation (PWM) dead-time, are the vital aspects while designing higher power density converters. The dead-time in the PWM can be reduced/removed in the proposed converter. This will increase the voltage/current gain and enhance the quality of the voltage/current waveforms even at lower modulation index and light loads than the traditional flying capacitor (FC) and neutral point clamped (NPC) converters. Furthermore, an improved phase-shifted PWM (IPS-PWM) is used to maintain the flying capacitor’s nominal reference voltage. A comparison is made between SIFC and five different existing multilevel topologies. The proposed converter has higher voltage/current gain, lower THD over conventional FC and NPC converters, and higher efficiency than the other three topologies. Finally, the SIFC converter’s robustness with IPS-PWM is validated using experimental results in different operating conditions such as sudden load changes, modulation index, output frequency, and power factor (unity, lagging, leading).

20 February 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
HCHonnyong Cha
Honnyong Cha
The paralleled H-bridge multilevel current source inverter (PHB-MLCSI) is widely used in industry, especially for high-power and medium-voltage applications. Even so, the risk of an open circuit fault (OCF), which is the most common and destructive failure among all conventional CSIs also jeopardizes the reliability of the standard PHB-MLCSI. To overcome this major shortcoming, a new topology called paralleled H-bridge multilevel switching-cell current source inverter (PHB-MLSC2SI) is introduced in this paper. Thus, OCF is no longer an issue in the proposed topology, even if it occurs frequently or is caused by switch turn ON mismatch/delay among all complementary switches in every switching cycle. The phase-shifted pulse width modulation (PS-PWM) method is used to control the proposed topology due to the following two reasons: 1) other PWM schemes such as level shifted and low/fundamental frequency or half-cycle PWMs cannot overcome OCF if it occurs frequently; 2) mismatches in gating signals, tolerance in parameters of the input dc smoothing inductors (chokes), and unequal input dc voltage values are other concerns in the PHB-MLCSI that may deteriorate the performance of the converter. The PS-PWM method with redundant switching states is a proper modulation technique to handle all the aforementioned mismatch issues to an acceptable level. A variety of experimental tests are conducted to validate the feasibility of the proposed solution. And finally, a comparison is drawn between the proposed circuit and three other existing MLCSIs, further highlighting its distinctive features.

24 July 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
HCHonnyong Cha
Honnyong Cha
The paralleled H-bridge multilevel current source inverter (PHB-MLCSI) provides a practical means to enhance both the system’s current rating and power quality simultaneously. Even so, challenges such as separate dc sources and the need for bulky input dc inductors present notable obstacles in the PHB-MLCSI with an independent dc-link configuration, potentially increasing the system’s cost and size. The PHB-MLCSI with a shared dc-link, also known as the single-rating MLCSI (SR-MLCSI), can overcome these limitations. However, the SR-MLCSI faces the issue of open-circuit fault (OCF), similar to other traditional CSIs. Recently, a topology known as paralleled H-bridge multilevel switching-cell current source inverter (PHB-MLSC 2 SI) has been proposed in the literature to address the OCF issue in conventional PHB-MLCSI. However, this topology retains the same limitations as those mentioned for PHB-MLCSI. This paper proposes a modified version of SR-MLCSI, termed SR-MLCSI with fault tolerance (SR-MLCSIFT), to address the OCF issue in SR-MLCSI and mitigate the size, weight, cost, and complexity drawbacks of PHB-MLCSI and PHB-MLSC 2 SI. Additionally, the article investigates several extremely severe faulty scenarios for the first time within the proposed topology. A detailed operational principle of the suggested inverter under OCF conditions is provided, accompanied by a comprehensive comparison with several MLCSI counterparts. Extensive experimental tests are conducted to validate the effectiveness of the proposed solution.

24 July 2024 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
HCHonnyong Cha
Honnyong Cha
A topology with a reduced component count, referred to as the different multilevel current source inverter (DML-CSI), has been introduced in the literature. However, similar to other CSIs, DML-CSI also suffers from the issue of open-circuit faults (OCFs), which are reported to be the most common and destructive failures in industrial settings. In addressing this significant drawback, this article introduces a new configuration termed the fault-tolerant switching-cell CSI (FT-SC 2 SI), derived from the DML-CSI circuit. To enhance the proposed topology's resilience against severe OCF scenarios and avoid the need for an additional closed-loop controller, the phase-shifted pulsewidth modulation (PS-PWM) method is employed. Notably, the proposed solution is straightforward and does not necessitate any fault diagnosis or other complex controllers. Furthermore, the PS-PWM operation under faulty conditions does not require modification. Likewise, the quality of the waveforms is not compromised during the faulty operating conditions. Experimental results are provided to substantiate the findings.

9 January 2025 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
FFFaramarz Faraji
Faramarz Faraji
NBNgo Bac Bien
Ngo Bac Bien
TTThien-Dung Tran
Thien-Dung Tran
DHDaheon Hong
Daheon Hong
HCHonnyong Cha
Honnyong Cha
The multilevel flying capacitor converter (ML-FCC) has garnered widespread recognition and adoption across various applications over decades. However, achieving an efficiency of ≥99% in the three-level (3L) version of this topology presents a significant challenge. To address this barrier and maximize the converter’s efficiency to the greatest extent possible, this article proposes three discontinuous phase-shifted pulse width modulation (DPS-PWM) techniques, which are applied to a 10 kW SiC MOSFET 3L-FCC. These modulation strategies inhibit power device switching when the waveforms reach their peak values, a region referred to as the nonswitching region (NSR) in this article. Even with a substantial load imbalance (>33%), the efficiency of the converter remains largely unaltered. The highest efficiency, achieved at 75% of full load, is approximately 99.55%, while maintaining an efficiency around 99.5% at full load, measured after one hour of fanless operation. Avoiding voltage ripple on flying capacitors (FCs), enhancing the utilization of the input dc voltage/source, and preventing losses associated with FCs and dead-time during the NSR are additional advantages of the proposed modulation approaches.