31 March 2023 in IEEE Transactions on Electron Devices
Avalanche photodiodes (APDs) can amplify the weak optical signal as well as enable higher receiver sensitivity due to the internal avalanche gain, but the impact ionization process can also introduce the “excess noise,” which limits the practically achievable signal-to-noise ratio (or sensitivity) and gain-bandwidth product. Hg $_{{1} -{x}}$ CdxTe electron-initialed APDs (e-APD) have been demonstrated to exhibit high performance in terms of gain and excess noise at 77 K. Here, we discuss the gain and excess noise properties of multiple Hg $_{{1}-{x}}$ CdxTe e-APDs with different Cd compositions targeting at short-wavelength infrared (SWIR), mid-wavelength infrared (MWIR), and long-wavelength infrared (LWIR) band operating at various temperatures. It demonstrates that the gain of APDs increases as the temperature decreases and the cutoff wavelength of the devices increases, which is related to the decrease of electron effective mass, optical photon scattering rate, and bandgap of the materials. In addition, the low excess noise of less than 1.6 at high gains is also achieved for the devices over a wide range of temperatures. The large spin-orbit splitting energy ( $\Delta $ so) in comparison to bandgap energy is considered to be responsible for the observed pure electron avalanche and exceptionally low excess noise. This work may provide insight into the low-noise HgCdTe APDs and is beneficial for the future applications of high-temperature operating and high-performance optical receivers.
6 November 2023 in Applied Physics Letters
Digital alloy (DA) InAlAs on the InP substrate exhibits a lower excess noise compared to a traditional In0.52Al0.48As random alloy as the multiplication layer in avalanche photodiodes (APDs). This work implements DA InAlAs as the multiplication layer in a 1550 nm separate absorption, grading, charge, and multiplication APD and characterizes the performances through various analyses. The device reaches a maximum gain of 221 before avalanche breakdown, with a maximum gain-bandwidth product of more than 140 GHz. At 90% breakdown voltage, the dark current density is 4.1 mA/cm2, and the responsivity is 0.48 A/W at unit gain. Excess noise factors were identified, yielding an effective k value of around 0.15, which is lower than that of random alloy In0.52Al0.48As APDs (k ∼0.2). These findings show that DA InAlAs has the potential to be a promising material for high-performance APDs.
10 January 2024 in IEEE Photonics Technology Letters
In this work, we demonstrate two InGaP/AlGaAs heterojunction avalanche photodiodes with Al component of 0.8 and 0.6 for Li-Fi applications in near-UV and visible light bands. The devices exhibit high multiplication gain, low dark current, and low excess noise factor. By incorporating an InGaP p-layer with a low recombination velocity, we overcome the issue of low UV and near-UV response caused by the high surface recombination of GaAs and AlGaAs materials. The ${Al_{0.8}Ga_{0.2}As}$ device with a recessed window showed an external quantum efficiency (EQE) of 13.12% at 355 nm and 27.12% at 405 nm, with a peak EQE of 38.72% at 440 nm. The ${Al_{0.6}Ga_{0.4}As}$ device exhibits a peak EQE of 43.55% at 540 nm. Furthermore, the photodiodes demonstrate a 3 dB bandwidth of up to 1.59 GHz at 405 nm and 1.12GHz at 520 nm at 99% breakdown voltage. This indicates their future potential for applications in short-distance visible and near-UV light communications.