5 November 2024 in IEEE Transactions on Circuits and Systems I: Regular Papers
There are lots of works on the bandwidth extension of symmetrical Doherty power amplifier (S-DPA) with a back-off range of 6 dB. However, it is still a challenge to simultaneously extend the bandwidth and back-off range of a S-DPA. This paper proposes a design methodology for extending the back-off range of a broadband S-DPA. Nonlinear current profile is introduced into the carrier sub-amplifier of the S-DPA. In this way, unequal power will be delivered to the load by the carrier and peaking amplifiers, leading to an extended high efficiency power range. More importantly, compared with previous works, the inversion ratio of the impedance inverter after the carrier transistor will be reduced in the proposed S-DPA, increasing the operation bandwidth. The combiner parameters of the proposed S-DPA with extended back-off range are derived based on a pre-determined nonlinear current profile. It is illustrated that the combiner parameters of the S-DPA can be expressed as a function of the combining load. Then, the bandwidth of the proposed S-DPA is subsequently analyzed under different combining load conditions. As a validation, a 1.4–2.2 GHz S-DPA with extended back-off range is implemented in this paper. Under a continuous-wave (CW) signal excitation, the fabricated S-DPA achieves a maximum output power of 40.2–43 dBm, a saturation drain efficiency (DE) of 56%–74% and a 9.0 dB back-off DE of 45%–52.5% over 1.4–2.2 GHz. Moreover, the fabricated S-DPA is also measured by the excitation of a 20 MHz modulated signal with a peak-to-average power ratio (PAPR) of 8.0 dB. The measured adjacent channel leakage ratios (ACLRs) of the fabricated S-DPA changes from $-$ 30.7 dBc to $-$ 21.1 dBc at the lower band and from $-$ 31.9 to $-$ 21.1 dBc at the upper band over 1.4–2.2 GHz when the average output power is 33.0 dBm.
16 January 2025 in AEU - International Journal of Electronics and Communications
6 May 2025 in IEEE Microwave and Wireless Technology Letters
In this letter, piecewise linear current profile is introduced into the carrier amplifier of a symmetric three-stage Doherty power amplifier (TS-DPA) to extend the high-efficiency power range. According to the expected output back-off (OBO) range, the design parameters of the TS-DPA combiner are calculated based on the piecewise linear carrier current. Then the bandwidth of the proposed TS-DPA is analyzed and optimized through carefully selecting the combining load impedance. A symmetric TS-DPA operating in the 1.3–1.8-GHz frequency range is designed and fabricated to verify the proposed theory. The fabricated TS-DPA obtains drain efficiencies (DEs) of 41.6%–51.8% and 50.5%–58.4% at 11-dB OBO and saturation power levels, respectively. Moreover, a 40-MHz long-term evolution (LTE) modulated signal with a peak-to-average ratio (PAPR) of 9 dB is used to measure the fabricated DPA. The measured adjacent channel leakage ratios (ACLRs) at 1.4 and 1.7 GHz are below −47 dBc after digital predistortion (DPD).
27 January 2025 in AEU - International Journal of Electronics and Communications
6 August 2025 in IEEE Transactions on Circuits and Systems I: Regular Papers
Though Outphasing power amplifier (OPA) exhibits high efficiency across a wide dynamic power range, its frequency coverage is constrained, prompting novel design techniques to enable broadband or multi-band operation. This paper proposes a mode expansion methodology for OPAs that adopt a non-commensurate transmission line combiner (NCTLC). It is indicated in this paper that an NCTLC-based OPA has eight distinct operation modes by judiciously expanding the delta length and base length of the NCTLC, as well as reconfiguring the Outphasing angle. Theoretical analyses confirm that the performance advantages of the OPA can be preserved before and after mode expansion. It is precisely the multi-mode operation that enhances the design flexibility of NCTLC-based OPAs. Moreover, to efficiently design the NCTLC, a relationship between the back-off range of the OPA and the delta length of the NCTLC is established. For experimental validation, three prototypes are designed and fabricated using Wolfspeed CGH40010F devices. Among these, two single-band OPAs operate at 1.0 GHz and 1.2 GHz, and a dual-mode dual-band OPA operates at 1.96/2.48 GHz. The measurement results indicate that the saturation output power of all OPAs is greater than 43.1 dBm with drain efficiency (DE) of above 56%. In the meantime, the 6 dB back-off DEs of all OPAs exceed 50.5%.
8 December 2025 in IEEE Microwave and Wireless Technology Letters
The baseband impedance has a significant effect on the drain efficiency (DE) of a concurrent power amplifier (PA). In this letter, a low-pass filter-based baseband impedance control circuit (BICC) is proposed for improving the concurrent efficiency of a broadband Doherty PA (DPA). The proposed BICC provides the carrier and peaking PAs with a low baseband impedance over a wide frequency range. Moreover, to extend the high-efficiency power range, asymmetrical drain bias voltages are applied to the carrier and peaking transistors. As a validation, a 1.8–2.1-GHz asymmetrical-biased DPA is implemented and measured in this work. When the fabricated DPA is stimulated by a balanced 1.8/2.1-GHz concurrent signal, it achieves a maximum concurrent output power of 40.3 dBm with a DE of 52.4%. At the 8-dB output back-off (OBO) power level, the measured concurrent DE is 47.8%.