We tested the hypothesis that the degree of adaptation to highly focused sprint training at opposite ends of the sprint Force-Velocity (FV) spectrum would be associated with initial sprint FV profile in rugby athletes. Training-induced changes in sprint FV profiles were computed before and after an eight-week in-season resisted or assisted sprint training protocol, including a three-week taper. Professional male rugby players (age: 18.9 ± 1.0 years; body height: 1.9 ± 0.0 m; body mass: 88.3 ± 10.0 kg) were divided into two groups based on their initial sprint FV profiles: 1) Heavy sled training (RESISTED, N = 9, velocity loss 70–80%), and 2) assisted acceleration training (ASSISTED, N = 12, velocity increase 5–10%). A total of 16 athletes were able to finish all required measurements and sessions. According to the hypothesis, a significant correlation was found between initial sprint FV profile and relative change in sprint FV profile (RESISTED: r = −0.95, p < 0.01, ASSISTED: r = −0.79, p < 0.01). This study showed that initial FV properties influence the degree of mechanical response when training at different ends of the FV spectrum. Practitioners should consider utilizing the sprint FV profile to improve the individual effectiveness of resisted and assisted sprint training programs in high-level rugby athletes.
14 November 2021 in Scandinavian Journal of Medicine & Science in Sports
Clear decreases in horizontal force production capacity during sprint acceleration have been reported after hamstring injuries (HI) in football players. We hypothesized that lower FH0 is associated with a higher HI occurrence in football players. We aimed to analyze the association between sprint running horizontal force production capacities at low (FH0) and high (V0) velocities, and HI occurrence in football. This prospective cohort study included 284 football players over one season. All players performed 30 m field sprints at the beginning and different times during the season. Sprint velocity data were used to compute sprint mechanical properties. Players’ injury data were prospectively collected during the entire season. Cox regression analyses were performed using new HI as the outcome, and horizontal force production capacity (FH0 and V0) was used at the start of the season (model 1) and at each measurement time point within the season (model 2) as explanatory variables, adjusted for individual players’ (model 2) age, geographical group of players, height, body mass, and previous HI, with cumulative hours of football practice as the time scale. A total of 47 new HI (20% of all injuries) were observed in 38 out of 284 players (13%). There were no associations between FH0 and/or V0 values at the start of the season and new HI occurrence during the season (model 1). During the season, a total of 801 measurements were performed, from one to six per player. Lower measured FH0 values were significantly associated with a higher risk of sustaining HI within the weeks following sprint measurement (HR = 2.67 (95% CI: 1.51 to 4.73), p < 0.001) (model 2). In conclusion, low horizontal force production capacities at low velocity during early sprint acceleration (FH0) may be considered as a potential additional factor associated with HI risk in a comprehensive, multifactorial, and individualized approach.
To directly compare five commonly used on-field systems (motorized linear encoder, laser, radar, global positioning system, and timing gates) during sprint acceleration to (i) measure velocity–time data, (ii) compute the main associated force–velocity variables, and (iii) assess their respective inter-trial reliability. Eighteen participants performed three 40 m sprints, during which five systems were used to simultaneously and separately record the body center of the mass horizontal position or velocity over time. Horizontal force–velocity mechanical outputs for the two best trials were computed following an inverse dynamic model and based on an exponential fitting of the position- or velocity-time data. Between the five systems, the maximal running velocity was close (7.99 to 8.04 m.s−1), while the time constant showed larger differences (1.18 to 1.29 s). Concurrent validity results overall showed a relative systematic error of 0.86 to 2.28% for maximum and theoretically maximal velocity variables and 4.78 to 12.9% for early acceleration variables. The inter-trial reliability showed low coefficients of variation (all <5.74%), and was very close between all of the systems. All of the systems tested here can be considered relevant to measure the maximal velocity and compute the force–velocity mechanical outputs. Practitioners are advised to interpret the data obtained with either of these systems in light of these results.
While fatigue can be defined as an exercise-related decrease in the maximal power or isometric force, most studies have assessed only isometric force. The main purpose of this experiment was to compare dynamic measures of fatigue [maximal torque (Tmax), maximal velocity (Vmax) and maximal power (Pmax)] with measures associated with maximal isometric force [isometric maximal voluntary contraction (IMVC) and maximal rate of force development (MRFD)] 10 s after different fatiguing exercises and during the recovery period (1-8 min after). Ten young men completed 6 experimental sessions (3 fatiguing exercises×2 types of fatigue measurements). The fatiguing exercises were: a 30-s all out (WING), 10-min at severe-intensity (SEV) and 90-min at moderate-intensity (MOD). Relative Pmax decreased more than IMVC after WING (p=0.005) while the opposite was found after SEV (p=0.005) and MOD tasks (p<0.001). There was no difference between the decrease in IMVC and Tmax after the WING, but IMVC decreased more than Tmax immediately following and during the recovery from the SEV (p=0.042) and MOD exercises (p<0.001). Depression of MRFD was greater than Vmax after all the fatiguing exercises and during recovery (all p<0.05). Despite the general definition of fatigue, isometric assessment of fatigue is not interchangeable with dynamic assessment following dynamic exercises with large muscle mass of different intensities, i.e. the results from isometric function cannot be used to estimate dynamic function and vice-versa. This implies different physiological mechanisms for the various measures of fatigue.