7 November 2021 in Advanced Materials Interfaces
20 November 2014 in IEEE Transactions on Applied Superconductivity
A high gradient magnetic separator (HGMS) used for recovery of waste electric and electronic equipment has been designed and fabricated in the Institute of High Energy Physics of China. It has a warm bore of 200 mm diameter and consists of two superconducting solenoid coils made of epoxy-impregnated NbTi/Cu superconductors. The designed center field is 5 T, and the field gradient more than 36 T/m. The magnet suffered several trainings to reach its designed current of 153 A and stably operated during many charging and discharging. In this paper, the detailed development of this magnet is presented.
28 May 2026 in Biomass and Bioenergy
19 March 2026 in SSRN Electronic Journal
Lignin is a promising low-cost, widely available precursor for supercapacitor electrodes, yet conventional preparation methods yield carbons with limited pore structures and poor ion transport, hampering rate performance. Herein, we develop a green strategy combining electrospinning and solvent evaporation, using lignin and cellulose acetate as precursors. Through synergistic multi-solvent volatilization, we fabricate all-bio-based hierarchically porous carbon nanofibers. The lignin-to-cellulose acetate ratio significantly impacts fiber morphology, pore structure, and electrochemical properties. At an optimal 8:2 ratio, the resultant material (PCF-2) possesses a micro-meso-macroporous architecture, with a specific surface area of 305.81 m2 g-1 and a pore volume of 0.1516 cm3 g-1. As an electrode, the ion diffusion coefficient of PCF-2 has increased by four times compared to the unmodified electrodes. Hence, the PCF-2 delivers a specific capacitance of 287.98 F g-1 at 0.5 A g⁻¹ and retaining over 84% capacitance at 5 A g-1, demonstrating excellent rate capability. A symmetric PCF-2//PCF-2 supercapacitor achieves an energy density of 27.54 Wh kg-1 at 400 W kg⁻¹ and maintains 97.95% capacitance after 5000 cycles. This work offers a novel approach for high-performance, high-rate lignin-based supercapacitors.
4 March 2026 in SSRN Electronic Journal
Lignin, a renewable resource, is eco-friendly but has low graphitization in carbon materials, limiting its energy storage applications. This study proposes iodine treatment to enhance non-covalent interactions within lignin, achieving high-graphitization lignin-based carbon (IALC). TG-DSC, SEM, TEM, XRD, and Raman analyses show iodine treatment improves lignin's thermodynamic properties, increases carbonization yield, and enhances graphite microcrystal formation. IALC electrodes exhibit significantly higher specific capacitance (350.2 to 1090.7 mF cm⁻² at 0.2 A cm⁻²; 132.2 to 588.0 mF cm⁻² at 10 A cm⁻²) and lower series resistance (2.31 to 1.27 Ω) and charge-transfer resistance (6.97 to 1.61 Ω). Trasatti analysis confirms graphitization drives property enhancement. IALC-4//IALC-4 supercapacitors achieve 61.27 mWh cm⁻² energy density at 100 mW cm⁻² power density, maintaining 25.55 mWh cm⁻² at 5000 mW cm⁻², with over 90.69% capacitance retention after 10,000 cycles. This approach offers a novel, high-value utilization of lignin for electrode materials.