Gamma logging for uranium exploration is currently based on total counting with Geiger-M|ller gas detectors or NaI(Tl) scintillators. However, the total count rate interpretation in terms of uranium concentration may be impaired in case of roll fronts, when the radioactive equilibrium of the natural 238U radioactive chain is modified by the differential leaching of uranium and its daughter radioisotopes radium, radon, etc. Indeed, in the case of secular equilibrium, more than 95 % of gamma rays emitted by uranium ores come from 214Pb and 214Bi isotopes, that are in the back-end of the 238U decay chain. These two isotopes might produce an intense gamma signal even when uranium is not present, or with a much smaller activity, in the ore. Therefore, gamma spectroscopy measurements of core samples are performed in surface with HPGe detectors to directly characterize uranium activity from the 1001 keV gamma ray of 234mPa that is in the beginning of the 238U chain. However, due to the low intensity of this gamma ray, acquisitions of several hours are needed. In view to characterize uranium concentration within a few minutes, we propose a method using both the 92 keV gamma rays of 234Th and 235U, and the 98.4 keV uranium X-ray. This last is due to uranium self-induced fluorescence caused by gamma rays of the uranium chain, mainly 214Pb and 214Bi. The gamma rays of 214Pb and 214Bi undergo scatterings in the sample leading to photons with an energy in the 100 keV range that favor photoelectric interactions, and thus fluorescence. The comparison of the uranium activity obtained with the 92 keV and 98.4 keV lines allows detecting a uranium heterogeneity in the ore. Indeed, in the case of uranium nugget, the 92 keV peak leads to underestimated uranium concentration due to gamma self-absorption, but on the contrary the 98.4 keV peak leads to an overestimation because of increased fluorescence. In order to test this new approach, tens of uranium ore samples have.