This article describes a single-ended (SE) clock-referenced PAM3 (CR-PAM3) transceiver that achieves an energy efficiency of 0.275 pJ/b at a high data rate of 42 Gb/s. The proposed CR-PAM3 signaling provides tolerance to supply noise and reference offset in SE chiplet or die-to-die (D2D) interfaces by using forwarded clock as reference voltages instead of generating them at the RX side. To minimize power consumption for PAM3, a differentially weighted data driver is employed. The proposed XTC-combined FS-puller helps voltage level transition while canceling FEXT from adjacent channels. A decision feedback equalizer (DFE)-embedded sampler enables low-power feedback within 1 UI by eliminating the CML summer structure and directly adding a tap branch to the sampler. A digital on-chip foreground training sequence is used to sequentially train TX per-lane deskew, clock swing level, and RX quadrature error corrector (QEC). Six data lanes, two clock lanes, and one replica lane for testing are implemented using an on-chip 2-mm channel in a 28-nm CMOS technology. In the presence of 200-mVpp 120-MHz sinusoidal supply noise injected at TX, horizontal and vertical eyes with CR-PAM3 are measured as 0.34 UI and 121 mV at BER $\lt 10^{-12}$ , while the conventional PAM3 eye is closed.
12 January 2026 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
As the demand for high-speed memory interfaces continues to grow, the need for effective testing methodologies becomes increasingly critical. Traditional automatic test equipment (ATE) systems are limited in their capability to test advanced signaling methods such as pulse amplitude modulation-4 (PAM-4) due to their reliance on non-return-to-zero (NRZ) signaling. This article presents a PAM-4 transceiver designed to bridge the gap between the tester and the memory, boosting the PAM-4 testing data rate up to 48 Gb/s using existing NRZ-based ATE. The proposed work provides enhanced transition slope and ratio level mismatch (RLM) control through precise gate voltage adjustment, resulting in improved test accuracy. The prototype was fabricated in 40-nm CMOS technology and occupies an active area of 2.34 mm2. The proposed work operates at 48 Gb/s/pin, demonstrating an energy efficiency of 1.85 pJ/bit in write mode and 2.97 pJ/bit in read mode for the PAM-4 test, respectively.
1 August 2026 in IEEE Transactions on Circuits and Systems II: Express Briefs