31 January 2020 in ACS Applied Nano Materials
19 September 2017 in Advanced Engineering Materials
The authors demonstrate, in this work, a fascinating synergism of a high surface area heterojunction between TiO2 in the form of ordered 1D anodic nanotube layers of a high aspect ratio and ZnO coatings of different thicknesses, produced by atomic layer deposition. The ZnO coatings effectively passivate the defects within the TiO2 nanotube walls and significantly improve their charge carrier separation. Upon the ultraviolet and visible light irradiation, with an increase of the ZnO coating thickness from 0.19 to 19 nm and an increase of the external potential from 0.4–2 V, yields up to 8‐fold enhancement of the photocurrent density. This enhancement translates into extremely high incident photon to current conversion efficiency of ≈95%, which is among the highest values reported in the literature for TiO2 based nanostructures. In addition, the photoactive region is expanded to a broader range close to the visible spectral region, compared to the uncoated nanotube layers. Synergistic effect arising from ZnO coated TiO2 nanotube layers also yields an improved ethanol sensing response, almost 11‐fold compared to the uncoated nanotube layers. The design of the high‐area 1D heterojunction, presented here, opens pathways for the light‐ and gas‐assisted applications in photocatalysis, water splitting, sensors, and so on.
14 August 2018 in Nanoscale
A novel 1D conical nanotubular CdS/TiO2heterostructure possesses synergic effects that yield a superior photon-to-electron conversion and shows promising perspectives in photovoltaics.
28 November 2019 in Nanoscale
A novel 1D nanotubular TiO 2 /MoS 2 nanosheet heterostructure possesses synergistic effects that yield superior photon-to-electron conversion and photocatalysis.
9 June 2020 in RSC Advances
Laser treatment of amorphous TiO 2 nanotube layers leads to their crystallization without deformation or formation of the thermal oxide layer.
21 September 2020 in Journal of Applied Polymer Science
A comparison of the electrostatic and centrifugal spinning of poly(vinyl alcohol) and poly(vinyl pyrrolidone) is shown in terms of the resulting fiber morphology and the process conditions. Specific parameters of centrifugal spinning, such rotational speed of spinneret and the relative humidity, were extensively investigated in details. Morphologies and diameters of resulting fiber mats were investigated by a scanning electron microscopy and compared between the two spinning techniques. The results revealed that formation of fibers is mainly affected by the initial polymer concentrations (and resulting viscosities) of polymeric solutions, which is in line with previous reports. However, the key novel finding of this work is that increasing relative humidity during centrifugal spinning process leads to greatly reduced fiber diameters to the levels typical for electrospinning. The obtained comparison is discussed and clearly shows technological advantages of the centrifugal spinning over electrospinning, enabling quantitative production of fibers with same or similar diameters.