This paper proposes a single-switch integrated Sepic converter with a Y-source coupled inductor. The three-winding coupled inductor has higher voltage regulation efficiency, and the three-port tap of the y-source is easier to integrate with other structures to form a composite power cell. While ensuring the continuous input current, it can flexibly adjust the voltage gain, increase the power capacity, and reduce the voltage stress of the switch. The diode-capacitor branch in the integrated topology is used as a clamp to suppress the voltage shock while using the absorbed leakage energy to achieve soft-switching characteristics, mitígate diode reverse recovery, and improve the efficiency of the converter. The converter can be applied to the output of the photovoltaic (PV) array, a detailed theoretical analysis of the converter is carried out, and the general extension of the topology and the extension of the converter family are given. Finally, a 150 W prototype was built to verify that the converter can achieve high gain under high efficiency.
An interleaved Buck-Boost-Zeta converter with the coupled inductor multiplier cell and zero input current ripple is proposed in this paper, which is suitable for high step-up applications such as the photovoltaic generation system. By integrating the Buck-Boost converter with the Zeta converter and adding the coupling inductor voltage multiplier cell and the auxiliary input inductor, the proposed converter achieves very high voltage gain and very low switch voltage stress. At the same time, very low input current ripple and continuous output current can be achieved, which is friendly to photovoltaic arrays and DC-bus. The leakage inductance energy is absorbed by the passive clamp circuit, the zero-current-switching (ZCS) turn-on of the switch is achieved and the reverse recovery problem of the diode is alleviated. The operation principles and performances of the proposed converter are analyzed in detail. The proposed converter can further improve the voltage gain by adding different voltage multiplier cells and their general structures are given. A prototype with 32V input and 400V output was built to verify the theoretical analysis.