The study is to investigate the physical, mechanical, and tribological properties of Al6063 alloy reinforced by Silicon Nitride (Si3N4) & compound Copper Nitrate (CuN2O6) processed via Powder Metallurgy (PM) Techniques. Incorporation of reinforcement in matrix material ranged from 6 to 12% Si3N4 in a 6-step interval, and 2 to 6%CuN2O6 in a two-step interval. The characterizations were made on the PM produced specimens using OM, EDS, XRD and hardness. The reinforcement particles were distributed uniformly is attributed by homogeneous mixer of matrix and reinforcements. The tests were carried out in accordance with ASTM Standards on the Al6063 alloy and its composites. The test findings show that as the reinforcing percentage of ceramic and inorganic compound is increased, properties such as hardness and density rise monolithically and considerably. The dispersion of Si3N4 and CuN2O6 reinforcement in the AA6061 matrix was ensured by x-ray diffraction patterns. In comparison to the base alloy, the hardness of AA6063/12%Si3N4/6% CuN2O6 improved by 88% due to the mismatch of thermal expansion between the Al matrix and reinforcement causes huge internal stress, causing the aluminium matrix to deform plastically to lodge the smaller volume expansion of Si3N4 and CuN2O6 particles. The dry sliding wear test was carried out on a tribometer with a pin-on-disc arrangement, and the findings show that the composite has a higher wear resistance. The Taguchi design of experiments was used to investigate the solution containing parameters employing an orthogonal array, the signal-to-noise ratio, and analysis of variance. The weight percentage of Si3N4/CuN2O6 compound and the relationship between wt% of reinforcement and applied load had the highest impact on composite wear resistance, accounted for 31.66%. Before and after the wear morphology during the wear test, images from a scanning electron microscope and energy dispersive microscopy were used to examine the manufactured composites.
This study investigates the effectiveness of fish scale biochar as a sustainable micro-filler for enhancing the mechanical, thermal, and tribological performance of jute fiber–reinforced epoxy composites. Six composite formulations were developed by varying the biochar content from 0 to 10 wt.% while maintaining a constant jute fiber loading of 45 wt.%. The incorporation of biochar significantly improved the composite properties, with the 4 wt.% formulation (JF-FSB4) exhibiting the highest tensile strength (61.48 MPa), flexural strength (100.63 MPa), interlaminar shear strength (20.47 MPa), tensile modulus (3.69 GPa), flexural modulus (4.65 GPa), impact strength (13.72 J), and hardness (76.58). Wear resistance increased progressively up to 6 wt.% biochar due to improved surface integrity and enhanced load-bearing capability, whereas higher filler levels resulted in performance reduction attributed to particle agglomeration. Water absorption decreased to a minimum of 2.98 % for the JF-FSB6 composite, indicating enhanced moisture resistance. Thermal conductivity increased steadily from 0.24 to 0.39 W/m·K with increasing filler content, driven by the formation of conductive carbonaceous pathways. Overall, the results demonstrate that fish scale biochar serves as an effective eco-friendly filler capable of improving mechanical stability, thermal performance, and wear resistance, making these composites suitable for lightweight engineering applications.