9 January 2025 in Nature Communications
Photon emission may be continuously produced from mechanical work through self-recoverable mechanoluminescence (ML). Significant progress has been made in high-performance ML materials in the past decades, but the rate-dependent ML kinetics remains poorly understood. Here, we have conducted systematic studies on the self-recoverable ML of Mn2+-doped SrZnOS (SrZnOS: Mn2+) under rapid compression up to ~10 GPa. Rate-dependent distinct kinetics is revealed: a diffuse-like ML behavior below ~1.2 GPa/s, oscillatory emission with a series of ML peaks at critical rate of ~1.2–1.5 GPa/s, and suppression of ML above 1.5 GPa/s. Analysis from the rate-independent structural evolution and photoluminescence under high pressures show that the oscillatory ML emission at the critical rate corresponds to multi-cyclic piezoelectrically-induced excitation (PIE) and self-recoverable processes. Both characteristic time (τ) for the PIE and self-recoverable processes are minimized at the critical rate, indicating the time limit of ML in the dynamic response to rapid compression. High temperature is slightly favorable for PIE, but is unfavorable for the self-recoverable process. The present work uncovers the temporal characteristics of self-recoverable ML and provides insight into understanding the rate-dependent ML kinetics in the mechanical-photon energy conversion, conducive to the design of ML-based optoelectronic devices.
1 December 2012 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
1 February 2013 in Radiation Measurements
1 February 2014 in Review of Scientific Instruments
We present a phase retrieval method (PRM) for analyzing single-phase displacement interferometry measurements on rapidly changing velocity histories, including photon Doppler velocimetry (PDV). PRM identifies the peaks and valleys as well as zero-crossing points in a PDV time series, performs normalization and extracts point-by-point phase and thus velocity information. PRM does not require a wide time window as in sliding window Fourier transformation, and thus improves the effective temporal resolution. This method is implemented in analyzing PDV data obtained from gas gun experiments, and validated against simultaneous measurements with velocity interferometer system for any reflector.
1 December 2023 in Review of Scientific Instruments
Rapid compression experiments performed using a dynamic diamond anvil cell (dDAC) offer the opportunity to study compression rate-dependent phenomena, which provide critical knowledge of the phase transition kinetics of materials. However, direct probing of the structure evolution of materials is scarce and so far limited to the synchrotron based x-ray diffraction technique. Here, we present a time-resolved Raman spectroscopy technique to monitor the structural evolutions in a subsecond time resolution. Instead of applying a shutter-based synchronization scheme in previous work, we directly coupled and synchronized the spectrometers with the dDAC, providing sequential Raman data over a broad pressure range. The capability and versatility of this technique are verified by in situ observation of the phase transition processes of three rapid compressed samples. Not only the phase transition pressures but also the transition pathways are reproduced with good accuracy. This approach has the potential to serve as an important complement to x-ray diffraction applied to study the kinetics of phase transitions occurring on time scales of seconds and above.