Alec M. Fischer

Alec M. Fischer

Auto-generated profile, based on publicly available information

Alec M. Fischer

Arizona State University 1 Department of Physics Tempe, Arizona 85287-1504, USA

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 May 2010 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SCSuk Choi
Suk Choi
HKHee Jin Kim
Hee Jin Kim
SKSeong-Soo Kim
Seong-Soo Kim
JLJianping Liu
Jianping Liu
JKJeomoh Kim
Jeomoh Kim
FPFernando A. Ponce
Fernando A. Ponce
InAlN electron-blocking layers (EBLs) are shown to improve the emission intensity and to mitigate the efficiency droop problem in III-nitride-based visible light-emitting diodes (LEDs). Using an In0.18Al0.82N EBL in blue LEDs, we have achieved a significant improvement in the electroluminescence emission intensity and a mitigated efficiency droop compared to similar LEDs without an EBL or with an Al0.2Ga0.8N EBL. This indicates that an In0.18Al0.82N EBL is more effective in electron confinement and reduces the efficiency droop possibly caused by carrier spill-over than conventional AlGaN EBLs.

8 March 2010 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
HKHee Jin Kim
Hee Jin Kim
SCSuk Choi
Suk Choi
SKSeong-Soo Kim
Seong-Soo Kim
JRJae-Hyun Ryou
Jae-Hyun Ryou
PYP. Douglas Yoder
P. Douglas Yoder
FPFernando A. Ponce
Fernando A. Ponce
Improvement of the internal quantum efficiency in green-light emitting diodes has been achieved using lattice-matched InAlN electron-blocking layers. Higher electroluminescence intensities have been obtained due to better electron confinement in the device active region. The device efficiency has also been found to significantly depend on the InAlN growth temperature. Optimized InAlN growth at ∼840 °C results in a lower growth rate and longer growth times than at ∼780 °C . The observed reduction in emission efficiency for InAlN layers grown at higher temperatures is possibly attributed to thermal damage in the green active region.

6 October 2014 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
XLXiaohang Li
Xiaohang Li
TDTheeradetch Detchprohm
Theeradetch Detchprohm
TKTsung-Ting Kao
Tsung-Ting Kao
MSMahbub Satter
Mahbub Satter
SSShyh-Chiang Shen
Shyh-Chiang Shen
MKMichael Kneissl
Michael Kneissl
Optically pumped deep-ultraviolet (DUV) lasing with low threshold was demonstrated from AlGaN-based multiple-quantum-well (MQW) heterostructures grown on sapphire substrates. The epitaxial layers were grown pseudomorphically by metalorganic chemical vapor deposition on (0001) sapphire substrates. Stimulated emission was observed at wavelengths of 256 nm and 249 nm with thresholds of 61 kW/cm2 and 95 kW/cm2 at room temperature, respectively. The thresholds are comparable to the reported state-of-the-art AlGaN-based MQW DUV lasers grown on bulk AlN substrates emitting at 266 nm. These low thresholds are attributed to the optimization of active region and waveguide layer as well as the use of high-quality AlN/sapphire templates. The stimulated emission above threshold was dominated by transverse-electric polarization. This work demonstrates the potential candidacy of sapphire substrates for DUV diode lasers.

11 March 2013 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
ZLZachary Lochner
Zachary Lochner
TKTsung-Ting Kao
Tsung-Ting Kao
YLYuh-Shiuan Liu
Yuh-Shiuan Liu
XLXiaohang Li
Xiaohang Li
MSMahbub Satter
Mahbub Satter
FPFernando A. Ponce
Fernando A. Ponce
Deep-ultraviolet lasing was achieved at 243.5 nm from an AlxGa1−xN-based multi-quantum-well structure using a pulsed excimer laser for optical pumping. The threshold pump power density at room-temperature was 427 kW/cm2 with transverse electric (TE)-polarization-dominant emission. The structure was epitaxially grown by metalorganic chemical vapor deposition on an Al-polar free-standing AlN (0001) substrate. Stimulated emission is achieved by design of the active region, optimizing the growth, and the reduction in defect density afforded by homoepitaxial growth of AlN buffer layers on AlN substrates, demonstrating the feasibility of deep-ultraviolet diode lasers on free-standing AlN.

15 October 2012 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SCSuk Choi
Suk Choi
MJMi-Hee Ji
Mi-Hee Ji
JKJeomoh Kim
Jeomoh Kim
HKHee Jin Kim
Hee Jin Kim
MSM. Satter
M. Satter
FPFernando A. Ponce
Fernando A. Ponce
Data and analysis are presented for the study of efficiency droop in visible III-nitride light-emitting diodes (LEDs) considering the effects of both electron spill-over out of active region and hole injection into the active region. Performance characteristics of blue LEDs with lattice-matched In0.18Al0.82N electron-blocking layers (EBLs) with different thicknesses were measured in order to exclude the effects of strain and doping efficiency of the EBL, and the quantum efficiencies were analyzed taking account of the electron spill-over current and the relative hole concentration. The results suggest that the highest efficiency in LEDs with a 15-nm In0.18Al0.82N EBL is due to relatively lower hole-blocking effect, hence higher hole injection than in LEDs with a 20-nm EBL, while providing a higher potential barrier for reduced electron spill-over than in LEDs with thinner EBLs. This study suggests that the EBL hole-blocking and electron-confinement effects should be considered in order to achieve higher light output power and reduced efficiency droop at high currents.

3 April 2009 in Applied Physics Express
Verified
Journal Article
Closed access
AFAlec M. Fischer
Alec M. Fischer
ZWZhihao Wu
Zhihao Wu
KSKewei Sun
Kewei Sun
QWQiyuan Wei
Qiyuan Wei
YHYu Huang
Yu Huang
FPFernando A. Ponce
Fernando A. Ponce