30 June 2014 in Journal of Materials Chemistry C
An organic dual-wavelength surface-emitting distributed feedback (DFB) laser based on a waveguide configuration containing a holographic photo-curable polymer/liquid crystal (LC) periodic structure and two laser gain media is reported for the first time. In such a laser configuration, a laser dye [4-(dicyanomethylene)-2-methyl-6-(p-dimethylaminostyryl)-4H-pyran, DCM]-doped polymer/LC periodic grating was formed on the top of a semiconducting laser gain [poly(2-methoxy-5-(2′-ethyl-hexyloxy)-p-phenylenevinylene), MEH-PPV] layer. A dual-wavelength laser emission at 627.8 nm and 606.6 nm was obtained from the two different laser gain media. The working mechanism of the two lasing behaviors and the methods to modulate lasing wavelength positions are elaborated and demonstrated, which shows the potential to extend the applications of organic lasers.
6 August 2015 in Optics Express
In adaptive optics system (AOS) for optical telescopes, the reported wavefront sensing strategy consists of two parts: a specific sensor for tip-tilt (TT) detection and another wavefront sensor for other distortions detection. Thus, a part of incident light has to be used for TT detection, which decreases the light energy used by wavefront sensor and eventually reduces the precision of wavefront correction. In this paper, a single Shack-Hartmann wavefront sensor based wavefront measurement method is presented for both large amplitude TT and other distortions’ measurement. Experiments were performed for testing the presented wavefront method and validating the wavefront detection and correction ability of the single-sensor based AOS. With adaptive correction, the root-mean-square of residual TT was less than 0.2 λ, and a clear image was obtained in the lab. Equipped on a 1.23-meter optical telescope, the binary stars with angle distance of 0.6″ were clearly resolved using the AOS. This wavefront measurement method removes the separate TT sensor, which not only simplifies the AOS but also saves light energy for subsequent wavefront sensing and imaging, and eventually improves the detection and imaging capability of the AOS.
7 October 2013 in Liquid Crystals
10 October 2012 in Liquid Crystals
In this study, three kinds of low-viscosity difluorooxymethylene-bridged (CF2O) liquid crystals (LCs) were synthesised. These materials exhibit low melting point and low viscosity at room temperature. The viscosity of the final LC mixture significantly decreased when LC compounds were mixed with high-birefringence (Δn) isothiocyanato LCs. The tested curves with varied temperatures of LC mixtures showed that some CF2O LC compounds could enhance the response performance of high-Δn LCs in a specific temperature range. Therefore, LC compounds with low viscosity could become a component of LC mixtures with fast response performance.
9 April 2015 in Applied Optics
The time delay engendered by wavefront sampling and data processing inevitability exists in almost all the wavefront sensor (WFS) based adaptive optics (AO) systems. Also, when WFS is used for tip–tilt aberration detection, the time delay significantly reduces the tip–tilt correction performance of the AO system. In this paper, we focus on researching time delay in a tip–tilt (TT) control system and introduce a predicted signal compensation method (PSCM) to compensate the time delay by modifying the WFS detected signals. Based on a precise model of a TT dynamic control system, the detection delay of TT corrections included in a WFS detected signal can be compensated. Experiments are conducted in the lab: the pure integrator (I), proportional and integral (PI) wavefront TT controllers, and these controllers with PSCM are compared to test the efficiency of the PSCM for TT corrections. For the PI controller, the rejection bandwidth increases from 52 to 62 Hz by using PCSM; meanwhile, the open-loop phase margin increases from 45 to 60 deg. In addition, astronomical observation results are also given based on the PI wavefront TT controller. The PSCM improves the Strehl ratio by a factor of 1.3. The new method is proven to improve the AO system closed-loop performance not only for increasing the closed-loop rejection bandwidth but also in favor of the error attenuation at low frequency. Furthermore, the method does not introduce more noise to the system.
1 February 2012 in Optics Communications